A nonlinear rheology model for mid‐ocean ridge axis topography
Authors:
- Yongshun ChenYCYongshun Chen
- W. Jason MorganWMW. Jason Morgan
- 10 October 1990
- journal article
- Published by American Geophysical Union (AGU) in Journal of Geophysical Research
- Vol. 95 (B11) , 17583-17604
Abstract
This paper describes a mechanical model of the mid‐ocean ridge axis based on a nonlinear rheology. The oceanic lithosphere is modeled as a strongly temperature‐dependent “power law” material with the Byerlee's friction law describing the brittle behavior of the upper oceanic lithosphere. We examined two simple models. A mantle‐only model predicted an axial rift valley 1–2 km deep and 10–15 km wide at slow half‐rates of 5–25 mm/yr which is in fair agreement with observations. However, the rift valley did not completely vanish at fast spreading rates even though its width and relief became much smaller. Thus, the mantle‐only model failed to explain the observed transition in axial topography with spreading rate. By including a uniform thickness oceanic crust with theological properties different from the mantle, our second model produced the first order variation of axial topography with spreading rate: a pronounced rift valley with 1–2 km relief at slow rates, a smaller relief (11 and the maximum shear strain rate ėmax are less than 10−17 s−1 which is in good agreement with the 10−18 s−1 average for oceanic brittle plate deformation inferred from seismic moment data. Within the ductile region (area beneath the 750°C isotherm) the strain rates are in the range of 10−14–10−16 s−1, except within a narrow band near the ridge axis where higher strain rates are located. We found that the thermal structure of the oceanic lithosphere is not very sensitive to the details of the mantle flow pattern (or the rheology) but is very sensitive to the cooling by hydrothermal circulation near the ridge axis. Axial structure is also influenced by factors other than the spreading rate. Within the range of slow and intermediate rates, our calculations show that the size of an axial rift valley decreases with an increase in either the thickness of the oceanic crust or the mantle temperature; in other words, a thinner crust or a cooler mantle temperature will produce a more pronounced rift valley. In the vicinity of hotspots, the absence of an axial rift valley even at slow spreading rates, such as the Reykjanes Ridge, can be well explained by the anomalously thicker crust and higher mantle temperatures. In contrast, at the Australian‐Antarctic Discordance a deeper than normal section of an intermediate spreading ridge has very rough topography not present on the adjacent sections of the ridge; this can be explained by our model as due to an anomalously low mantle temperature as has been suggested or perhaps also due to a thinner oceanic crustKeywords
This publication has 65 references indexed in Scilit:
- The strength of the continental crust, detachment zones and the development of plastic instabilitiesTectonophysics, 1989
- Rheological stratification of the lithosphereTectonophysics, 1987
- The influence of plate movement on the evolution of hydrothermal convection cells in the oceanic crustTectonophysics, 1986
- A tectonic model for ridge-transform-ridge plate boundaries: Implications for the structure of oceanic lithosphereTectonophysics, 1984
- Rheology of the lithosphereReviews of Geophysics, 1983
- Crustal processes at spreading centersReviews of Geophysics, 1983
- Deformation maps in grain-size-stress space as a tool to investigate mantle rheologyPhysics of the Earth and Planetary Interiors, 1982
- The experimental deformation of duniteTectonophysics, 1981
- Accurate Numerical Solutions for Elastic-Plastic ModelsJournal of Pressure Vessel Technology, 1979
- Accuracies of Numerical Solution Methods for the Elastic-Perfectly Plastic ModelJournal of Pressure Vessel Technology, 1977