Bond strength and hardness of light‐activated composite resins
Authors:
- 1 September 1984
- journal article
- research article
- Published by Wiley in Journal of Biomedical Materials Research
- Vol. 18 (7) , 789-796
Abstract
The bond strength of visible light-activated composites to etched enamel was measured as a function of exposure time. Studies have shown that the bottom surface may not be as hard as the top after customary cure times. Therefore this study also measured hardness and related it to enamel bonding. Plexiglas molds were used to simulate extracoronal applications where light is not attenuated by enamel. Bond strength and hardness of the bottom surfaces reached maximum values after the same exposure times with two of the three composites. More exposure time than normally recommended by manufacturers was needed to obtain maximum bond strength to enamel.Keywords
This publication has 7 references indexed in Scilit:
- Visible Light-Activated Resins — Depth of CureThe Journal of the American Dental Association, 1983
- Correlation between strength of bonding to enamel and mechanical properties of dental compositesJournal of Biomedical Materials Research, 1982
- In vitro Depth of Cure of Photo-activated CompositesJournal of Dental Research, 1982
- Ultraviolet light and ultraviolet light-activated composite resinsThe Journal of Prosthetic Dentistry, 1981
- The curing pattern of photo‐initiated dental compositesJournal of Oral Rehabilitation, 1980
- Factors Affecting the Depth of Cure of UV -polymerized CompositesJournal of Dental Research, 1980
- Curing depths of materials polymerised by ultra-violet lightBritish Dental Journal, 1979