The effect of testing parameters on coefficients of friction and adhesion in a similar process to injection moulding
- 2 September 2026
- journal article
- research article
- Published by Springer Nature in The International Journal of Advanced Manufacturing Technology
- p. 1-12
Abstract
No abstract availableKeywords
Funding Information
- Fundação para a Ciência e a Tecnologia (UID/05256)
- Fundação para a Ciência e a Tecnologia (UID/05256)
This publication has 46 references indexed in Scilit:
- The generation mechanism of demolding force based on the mold‐part interface contact mode in micro‐injection moldingPolymer Engineering & Science, 2023
- Temperature‐Dependent Adhesion in van der Waals HeterostructuresAdvanced Materials Interfaces, 2021
- A qualitative correlation between friction coefficient and steel surface wear in linear dry sliding contact to polymers with SGFFriction, 2014
- Introduction to Tribology2013
- Analysis of friction in the ejection of thermoplastic mouldingsThe International Journal of Advanced Manufacturing Technology, 2011
- INFLUENCE OF MOLD SURFACE COATINGS IN INJECTION MOLDING. APPLICATION TO THE EJECTION STAGE.International Journal of Material Forming, 2008
- Ejection force of tubular injection moldings. Part II: A prediction modelPolymer Engineering & Science, 2005
- Ejection force in tubular injection moldings. Part I: Effect of processing conditionsPolymer Engineering & Science, 2004
- On microscopic mechanisms of friction and wearWear, 1991
- Experimental investigation of the dependence of the coefficient of external static friction on temperatureRussian Physics Journal, 1974