Determination of the fracture toughness of polybutylene terephthalate (PBT) film by the essential work method: Effect of specimen size and geometry
Author:
- 1 March 2000
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 40 (3) , 798-808
Abstract
The fracture behavior of PBT films of thicknesses 0.125, 0.175, 0.275, 0.375 and 0.5 mm was investigated according to Essential Work of Fracture (EWF) method. Single edge and double edge notched specimens of varying ligament lengths were tested in tension producing load‐displacement traces that were typical of ductile failure. A linear relationship was obtained between the total specific work of fracture (W f ) and ligament length (L). This linearity was maintained as ligament length exceeded the plastic zone size or one third of sample width. It was found that while the specific essential work of fracture (W e ) was independent of thickness, the specific non‐essential work of fracture (βW p ) decreased with increasing thickness. It was found also, that work of fracture parameters were independent of the specimen width for the range of thicknesses used in the present study. Nevertheless, for a sample width of 20 mm, a lower w e and a higher βw p value was obtained. Good agreement was found between values of W e obtained from SENT and those obtained from DENT specimens; the value of βw p was consistently higher for SENT specimens.Keywords
This publication has 14 references indexed in Scilit:
- Deformation rate dependence of the essential and non-essential work of fracture parameters in an amorphous copolyesterPolymer, 1998
- Thickness dependence of work of fracture parameters of an amorphous copolyesterPolymer, 1997
- Work of fracture of PBT/PC blend: Effect of specimen size, geometry, and rate of testingPolymer Engineering & Science, 1997
- The essential fracture work concept for toughness measurement of ductile polymersPolymer Engineering & Science, 1996
- Determination of the fracture toughness of polymeric films by the essential work methodPolymer, 1994
- The plane‐strain essential work of fracture as a measure of the fracture toughness of ductile polymersPolymer Engineering & Science, 1990
- Effect of specimen geometry on the essential work of plane stress ductile fractureEngineering Fracture Mechanics, 1985
- Effects of pre-strain on plane stress ductile fracture in ?-brassJournal of Materials Science, 1980
- Critical review of some theories in fracture mechanicsInternational Journal of Fracture, 1968
- On discontinuous plastic states, with special reference to localized necking in thin sheetsJournal of the Mechanics and Physics of Solids, 1952