Investigating the effect of punch geometry on high speed tableting through radial die-wall pressure monitoring
- 3 August 2011
- journal article
- research article
- Published by Taylor & Francis in Pharmaceutical Development and Technology
- Vol. 18 (1) , 46-54
Abstract
Dwell time mainly depends on punch geometry, so some tableting problems such as capping and lamination could occur at high speed compaction. Robust tools are required to monitor the interaction of punch tip and powder bed at these high speeds. Our aim was to investigate the effect of punch geometry (flat and standard concave) on powder compaction at high speed using radial die-wall pressure (RDWP) as a monitoring tool. Instrumented die guided by compaction simulation was applied for five materials with different compaction behaviors. Flat-faced punch showed higher residual, maximum die-wall pressures, and axial stress transmission than concave punches, p < 0.003. Moreover, flat-faced punches showed less friction upon ejection, p < 0.003. Flat compacts showed higher elastic recovery, tensile strength, and required less work of compaction than convex compacts, p < 0.05. RDWP monitoring was a useful tool to prove that flat-faced punch induced higher radial stresses and particle/particle interactions in comparison to concave punch.Keywords
This publication has 23 references indexed in Scilit:
- Study of radial die-wall pressure changes during pharmaceutical powder compactionDrug Development and Industrial Pharmacy, 2010
- Tooling for Pharmaceutical Processing2008
- A modified Drucker-Prager Cap model for die compaction simulation of pharmaceutical powdersInternational Journal of Solids and Structures, 2008
- Numerical and experimental investigation of capping mechanisms during pharmaceutical tablet compactionPowder Technology, 2008
- Benefits of die-wall instrumentation for research and development in tablettingEuropean Journal of Pharmaceutics and Biopharmaceutics, 2004
- Analysis of tablet compaction. II. Finite element analysis of density distributions in convex tabletsJournal of Pharmaceutical Sciences, 2004
- Investigating Density Distributions for Tablets of Different Geometry During the Compaction of PharmaceuticalsParticulate Science and Technology, 2003
- The effect of wall friction in the compaction of pharmaceutical tablets with curved faces: a validation study of the Drucker–Prager Cap modelPowder Technology, 2003
- Effect of water on deformation and bonding of pregelatinized starch compactsEuropean Journal of Pharmaceutics and Biopharmaceutics, 1997
- Comparative compaction properties of various Microcrystalline Cellulose types and Generic ProductsDrug Development and Industrial Pharmacy, 1993