A Comprehensive Laboratory Screening of Three-Step Etch-and-Rinse Adhesives
Open Access
- 1 November 2014
- journal article
- Published by Operative Dentistry in Operative Dentistry
- Vol. 39 (6) , 652-662
Abstract
This study evaluated several bonding (microtensile bond strengths [μTBS], nanoleakage [NL], and in situ degree of conversion [ISDC] on dentin) and mechanical properties (ultimate tensile strength [UTS], degree of conversion [DC], water sorption [WS], and solubility [SL] in water) of four three-step etch-and-rinse adhesives in the short term. A total of 28 molars were used in this study. The dentin surfaces were bonded with the following adhesives: All-Bond 3 (ALB3); Fusion Duralink (FSDL); Optibond FL (OBFL), and Scotchbond Multi-Purpose (SBMP). After each adhesive-system application, composite resin build-ups were added. For bonding tests, specimens were sectioned in order to obtain bonded sticks. The sticks were divided to be tested for μTBS (0.5 mm/min), for NL (n=2), and ISDC (n=2). For NL, they were immersed in 50% silver nitrate and analyzed by scanning election microscopy. For ISDC, the hybrid layer was evaluated by micro-Raman spectroscopy. An hourglass-shaped matrix (UTS) or disk-shaped matrix (WS and SL) was filled with primer and adhesive (1:1 ratio) and light-polymerized. For UTS evaluation, the specimens were tested under tension. For WS and SL, specimens were desiccated and stored in distilled water to evaluate water diffusion kinetics over a 28-day period. The DC of the adhesives was evaluated by Fourier transformed infrared spectroscopy. The data from each test were analyzed by appropriate statistical methods. OBFL resulted in the highest μTBS, lower NL, higher ISDC and DC, and higher UTS than other adhesives (p0.05). ALB3 showed a higher NL and the lowest DC value. FSDL showed the highest NL and SL and the lowest ISDC. SBMP showed the lowest pattern of WS (p<0.05). OBFL showed the best results in all the properties evaluated, and it can be considered the gold standard of the three-step etch-and-rinse adhesive systems.Keywords
This publication has 46 references indexed in Scilit:
- Adhesives for the restoration of non-carious cervical lesions: A systematic reviewJournal of Dentistry, 2012
- A 13-year clinical evaluation of two three-step etch-and-rinse adhesives in non-carious class-V lesionsClinical Oral Investigations, 2010
- DENTIN/ENAMEL BONDINGJournal of Esthetic and Restorative Dentistry, 2010
- Clinical effectiveness of contemporary dentin bonding agentsJournal of Conservative Dentistry, 2010
- Influence of the hydrostatic pulpal pressure on droplets formation in current etch-and-rinse and self-etch adhesives: A video rate/TSM microscopy and fluid filtration studyDental Materials, 2009
- Effect of temperature on water sorption and solubility of dental adhesive resinsJournal of Dentistry, 2009
- Nanophase separation of polymers exposed to simulated bonding conditionsJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2008
- Systematic review of the chemical composition of contemporary dental adhesivesBiomaterials, 2007
- Water sorption and solubility of dentin bonding agents light-cured with different light sourcesJournal of Dentistry, 2007
- Effect of smear layer thickness and acidity of self-etching solutions on early and long-term bond strength to dentinJournal of Dentistry, 2005