Forming state recognition in deep drawing process with machine learning
Authors:
- 1 January 2019
- journal article
- research article
- Published by Japan Society of Mechanical Engineers in Journal of Advanced Mechanical Design, Systems, and Manufacturing
- Vol. 13 (3) , JAMDSM0066
Abstract
In press processing, quality inspection of a product is often carried out for each lot in the post process stage. When a failure occurs, it may result in a large number of defective products due to the fast processing speed. In order to prevent this, it is ideal to immediately stop the processing just after the defect occurs. Therefore, confirming the processing state in-process is required. This study proposes a new quality inspection method for deep drawing processes by using the count rate of acoustic emission (AE) signals. To analyze the AE count, deep learning, which is a multilayered neural network, is employed to recognize defects during a deep drawing process. The material used was a ductile material of cold rolled steel plate and is relatively difficult to find cracks during the deep drawing process. Characteristics were clarified by analysis of AE counts at plastic deformation and brake of material, and performing the forming state recognition experiment by a multilayer neural network (deep learning) showed a maximum recognition rate of 97.3%. High recognition rate was obtained despite the small number of data used.Keywords
This publication has 11 references indexed in Scilit:
- Design optimization of variable blank holder force trajectory and slide velocity in sheet metal formingTransactions of the JSME (in Japanese), 2018
- Study of factors affecting Springback in Sheet Metal Forming and Deep Drawing ProcessMaterials Today: Proceedings, 2018
- In-process Monitoring of Stamping Process of Thin PlateJournal of the Japan Society for Technology of Plasticity, 2016
- Human Sensing for Sleep Monitoring Using Film-Load SensorsJournal of Japan Society for Fuzzy Theory and Intelligent Informatics, 2016
- Prediction of Effective Press Motion Control to Improve Deep-Drawability of Steel Sheets with FE Forming AnalysisJournal of the Japan Society for Technology of Plasticity, 2014
- Reflection and Transmission Characteristics of Ultrasonic Waves in Flat Surface DieJournal of the Japan Society for Technology of Plasticity, 2013
- The Square Cup Deep Drawing by Variable Blank Holder Force(Machine Elements, Design and Manufacturing)TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series C, 2010
- Development of Die-embedded Micro-sensing SystemJournal of the Japan Society for Technology of Plasticity, 2010
- A multi-step analysis for determining admissible blank-holder forces in deep-drawing operationsMaterials & Design (1980-2015), 2009
- Amplitude Distribution of Acoustic Emission Signals in Plastic DeformationJournal of the Japan Institute of Metals and Materials, 1977