Metal loss and corrosion attack of FeCrAl overlay welds on evaporator tube shields of a waste‐fired power plant
Open Access
- 22 March 2024
- journal article
- research article
- Published by Wiley in Materials and Corrosion
- Vol. 75 (8) , 950-964
Abstract
Three FeCrAl alloys (APMT, EF100 and EF101) from Kanthal® and the reference Ni‐Cr Alloy 625 were used as weld cladding materials on tube shields in the evaporator tube bank of a waste‐fired combined heat and power plant. For each alloy type, the overlay welded tube shields were placed in both roof and floor positions within the evaporator for 6 months. The metal‐loss rate, the microstructure and hardness of the overlay welds before and after exposure and the corrosion products were analysed. The results showed higher metal‐loss rates in the welds placed in the roof position, confirming heterogeneities in the evaporator bank environment. Alloys were ranked from higher to lower erosion–corrosion resistance as follows: APMT ≈ Alloy 625 > EF101 > EF100. The analysis of the corrosion attacks showed a significant variation among the alloys, from a primarily homogeneous corrosion attack on APMT to intergranular corrosion in EF100 and pit formation in EF101.Keywords
This publication has 22 references indexed in Scilit:
- Exposure of FeCrAl Overlay Welds on Superheater Tubes: Influence of Local Environment on DegradationJournal of Failure Analysis and Prevention, 2022
- Field exposure of FeCrAl model alloys in a waste‐fired boiler at 600°C: The influence of Cr and Si on the corrosion behaviourMaterials and Corrosion, 2019
- The influence of silicon on the corrosion properties of FeCrAl model alloys in oxidizing environments at 600 °CCorrosion Science, 2018
- Oxidation Comparison of Alumina-Forming and Chromia-Forming Commercial Alloys at 1100 and 1200 °COxidation of Metals, 2017
- Corrosion Testing of Welds, A Review of MethodsWelding in the World, 2007
- Application of High Temperature Corrosion-Resistant Materials and Coatings Under Severe Corrosive Environment in Waste-to-Energy BoilersJournal of Thermal Spray Technology, 2007
- High temperature interaction of Al/Si-modified Fe–Cr alloys with KClCorrosion Science, 2007
- Novel Approaches to the Improvement of High Temperature Corrosion ResistanceMaterials and Corrosion, 2005
- The influence of alloying elements on the development and maintenance of protective scalesOxidation of Metals, 1995
- Embrittlement of ferritic stainless steelsMetallurgical Transactions A, 1980