Photovoltaic Flyback Microinverter With Tertiary Winding Current Sensing
- 14 November 2018
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 34 (8) , 7588-7602
Abstract
This paper presents a new low cost, non-invasive, and isolated current sensing technique for the grid-tied photovoltaic (PV) flyback microinverter. This is accomplished by using the flyback transformer itself as a current sensor, achieved by introducing a tertiary winding to the flyback transformer. The mathematical integration of the tertiary winding's open circuit voltage through a ground-clamped-integrator results in the sensing of the magnetizing current. Since the magnetizing current is a combination of both primary and secondary current, control of both grid current and maximum power point tracking (MPPT) is implemented by sensing only the magnetizing current. This allows the PV, primary, secondary, and the grid current loops to be free of any invasive current sensors. Moreover, controlling the magnetizing current provides an alternative solution to an inherent problem with continuous conduction mode (CCM), the control complexity. Linear ramping and de-ramping of the magnetizing current allows for a set-reset hysteresis control to be implemented, resulting in CCM control simplicity that is akin to the boundary and discontinuous conduction mode. A grid-tied microinverter prototype is presented for verification, achieving the following experimental result: 1.9% grid current THD, 0.9988 power factor, above 99% static MPPT efficiency and dynamic efficiency of 98.50%.Keywords
Funding Information
- UM Power Energy Dedicated Advanced Centre
- Higher Institution Centre of Excellence (UMPEDAC – 2016 (MOHE HICOE-UMPEDAC))
- Research University (RU002-2017)
This publication has 29 references indexed in Scilit:
- Hybrid Discontinuous/Boundary Conduction Mode of Flyback Microinverter for AC–PV ModulesIEEE Transactions on Power Electronics, 2015
- A High-Efficiency Flyback Micro-inverter With a New Adaptive Snubber for Photovoltaic ApplicationsIEEE Transactions on Power Electronics, 2015
- Analysis and Implementation of Phase Synchronization Control Strategies for BCM Interleaved Flyback MicroinvertersIEEE Transactions on Power Electronics, 2014
- An Interleaved High-Power Flyback Inverter for Photovoltaic ApplicationsIEEE Transactions on Power Electronics, 2014
- Weighted-Efficiency Enhancement Control for a Photovoltaic AC Module Interleaved Flyback Inverter Using a Synchronous RectifierIEEE Transactions on Power Electronics, 2014
- Volt‐second‐based control method for discontinuous conduction mode flyback micro‐inverters to improve total harmonic distortionIET Power Electronics, 2013
- Design and implementation of a grid‐tied wind power micro‐inverterIET Renewable Power Generation, 2013
- Soft-switching flyback inverter with enhanced power decoupling for photovoltaic applicationsIET Electric Power Applications, 2007
- A Review of Single-Phase Grid-Connected Inverters for Photovoltaic ModulesIEEE Transactions on Industry Applications, 2005
- Flyback Inverter Controlled by Sensorless Current MPPT for Photovoltaic Power SystemIEEE Transactions on Industrial Electronics, 2005