Electromigration failure mechanisms for SnAg3.5 solder bumps on Ti∕Cr-Cu∕Cu and Ni(P)∕Au metallization pads
Authors:
- 4 October 2004
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 96 (8) , 4518-4524
Abstract
The electromigration behavior of solder bumps is investigated under the current densities of and at . Different failure modes were observed for the two stressing conditions. When stressed at , damage occurred in both the anode/chip side and the cathode/chip side. However, failure happened only in the cathode/chip side under the stressing of . A three-dimensional simulation of the current-density distribution was performed to provide a better understanding of the current-crowding behavior in the solder bump. The current-crowding effect was found to account for the failure in the cathode/chip side. In addition, both the temperature increase and the thermal gradients were measured during the two stressing conditions. The measured temperature increase due to Joule heating was as high as , and the thermal gradient reached when stressed by . This induced thermal gradient may cause atoms to migrate from the chip side to the substrate side, contributing to the failure in the anode/chip side. Moreover, the formation of intermetallic compounds in the anode/chip side may also be responsible for the failure in the anode/chip side.
Keywords
This publication has 11 references indexed in Scilit:
- Recent advances on electromigration in very-large-scale-integration of interconnectsJournal of Applied Physics, 2003
- Electromigration study in SnAg3.8Cu0.7 solder joints on Ti/Cr-Cu/Cu under-bump metallizationJournal of Electronic Materials, 2003
- Systematic design of antireflection coating for semi-infinite one-dimensional photonic crystals using Bloch wave expansionApplied Physics Letters, 2003
- Current-crowding-induced electromigration failure in flip chip solder jointsApplied Physics Letters, 2002
- Electromigration of eutectic SnPb and SnAg3.8Cu0.7 flip chip solder bumps and under-bump metallizationJournal of Applied Physics, 2001
- Tin–lead (SnPb) solder reaction in flip chip technologyMaterials Science and Engineering: R: Reports, 2001
- Microstructure-electromigration correlation in a thin stripe of eutectic SnPb solder stressed between Cu electrodesApplied Physics Letters, 1999
- Phase Transformations in Metals and Alloys1992
- Electromigration in thin aluminum films on titanium nitrideJournal of Applied Physics, 1976
- Driving force in electromigrationPhysical Review B, 1974