Temperature dependence of the stacking-fault Gibbs energy for Al, Cu, and Ni
Open Access
- 26 December 2018
- journal article
- research article
- Published by American Physical Society (APS) in Physical Review B
- Vol. 98 (22) , 224106
Abstract
The temperature-dependent intrinsic stacking fault Gibbs energy is computed based on highly converged density-functional-theory (DFT) calculations for the three prototype face-centered cubic metals Al, Cu, and Ni. All relevant temperature-dependent contributions are considered including electronic, vibrational, magnetic, and explicit anharmonic Gibbs energy contributions as well as coupling terms employing state-of-the-art statistical sampling techniques. Particular emphasis is put on a careful comparison of different theoretical concepts to derive the stacking fault energy such as the axial-next-nearest-neighbor-Ising (ANNNI) model or the vacuum-slab approach. Our theoretical results are compared with an extensive set of previous theoretical and experimental data. Large uncertainties in the experimental data highlight the necessity of complementary parameter-free calculations. Specifically, the temperature dependence is experimentally unknown and poorly described by thermodynamic databases. Whereas calphad derived data shows an increase of the stacking fault energy with temperature for two of the systems (Cu and Ni), our results predict a decrease for all studied systems. For Ni, the temperature induced change is in fact so strong that in the temperature interval relevant for super-alloy applications the stacking fault energy falls below one third of the low temperature value. Such large changes clearly call for a revision of the stacking fault energy when modeling or designing alloys based on such elements.Keywords
Funding Information
- Deutsche Forschungsgemeinschaft
- European Research Council
- Horizon 2020 (639211)
This publication has 145 references indexed in Scilit:
- Impurity effect of Mg on the generalized planar fault energy of AlJournal of Materials Science, 2016
- Factors affecting the dissociation width of dissociated dislocations in FCC metals and alloysJournal of Materials Science, 2015
- Lambda transitions in materials science: Recent advances in CALPHAD and first‐principles modellingPhysica Status Solidi (b), 2013
- The influence of interstitial carbon on the γ-surface in austeniteActa Materialia, 2013
- The relation between ductility and stacking fault energies in Mg and Mg–Y alloysActa Materialia, 2012
- First-principles investigation of the effect of carbon on the stacking fault energy of Fe–C alloysActa Materialia, 2011
- The effect of alloying elements on the dislocation climbing velocity in Ni: A first-principles studyActa Materialia, 2009
- Predicting twinning stress in fcc metals: Linking twin-energy pathways to twin nucleationActa Materialia, 2007
- Atomistic modeling of the γ and γ′-phases of the Ni–Al systemActa Materialia, 2004
- Relative interfacial free energy measurements in Cu and Cu-Al alloysPhysica Status Solidi (a), 1970