The Design and Practical Realization of an Adaptable Grid Integrating Hydrogen Fuel Cell Setup With a Fuzzy-Logical Controller-Based SVPWM Boosted Inverter
Open Access
- 2 September 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 12, 123489-123513
Abstract
The primary and fundamental requirement for a fuel cell (FC) stack is its reliable operation under various operating conditions. When FC stacks are used as the input voltage source with high ripple currents, the overall lifespan of the FC system decreases. Hence, power converter configurations need to minimize the current ripples originating from these sources. Additionally, the generated voltage from the FC stack is often lower than the required voltage level for grid connection. This paper presents a fuzzy logic controller (FLC)-equipped high-gain single-switched DC-DC boost converter. The proposed power converter topology utilizes an improved switched inductor and switched capacitor configuration to minimize input current ripples and enhance the voltage gain. The switched inductor cell is designed in such a way that its inductors charge and discharge simultaneously, effectively minimizing the input current ripple. Additionally, the proposed DC-DC boost converter utilizes a switched capacitor cell to double the generated voltage. The FLC offers real-time visualization and digital signal processing capabilities, and it is compatible with MATLAB software. For grid connection purposes, a space vector pulse width modulation (SVPWM)-based switching system is recommended, utilizing a full bridge inverter. The SVPWM technique is implemented by representing the desired output voltage with an equivalent vector VREF rotating counterclockwise, integrated with a digital signal processing (DSP)-based controller. The DSP microcontroller employed in this study operates at an 80 Mb/sec sampling speed and offers several advantages, including the ability to perform complex calculations, implement advanced control algorithms, and process signals in real-time. These capabilities contribute to enhanced performance, efficiency, and accuracy. Laboratory studies have been conducted to validate the accuracy and effectiveness of the theoretical investigations.Keywords
This publication has 51 references indexed in Scilit:
- ARVIN converter: a bidirectional DC/DC converter for grid-connected G2V/V2G energy storage and electrification approachesElectrical Engineering, 2024
- A New PWM Technique for Three-Phase Three-Level Neutral Point Clamped RectifierArabian Journal for Science and Engineering, 2023
- Carrier-Based Variable Frequency PWM Technique for PMSM Drives to Achieve Dispersed Spectrum and Extended Low-Speed Operation CapabilityArabian Journal for Science and Engineering, 2023
- A New High Gain Boost Converter with Common Ground for Solar-PV Application and Low Ripple Input CurrentArabian Journal for Science and Engineering, 2023
- A novel switched-capacitor and fuzzy logic-based quadratic boost converter with mitigated voltage stress, applicable for DC micro-gridElectrical Engineering, 2022
- Experimental verification of interleaved hybrid DC/DC boost converterJournal of Power Electronics, 2022
- A novel robust reset controller implemented through field programmable gate array for oxygen ratio regulation of proton exchange membrane fuel cellComputers and Electrical Engineering, 2022
- A design for switched capacitor and single‐switch DC–DC boost converter by a small signal‐based PI controllerInternational Journal of Circuit Theory and Applications, 2022
- Sliding mode controller‐based e‐bike charging station for photovoltaic applicationsInternational Transactions on Electrical Energy Systems, 2020
- Design and application of PEM fuel cell-based cascade boost converterElectrical Engineering, 2019