Post-Fabrication Performance and Longevity Improvement of a Phase-Locked Loop With an On-Chip Phase Noise Measurement Circuit
- 19 April 2024
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 72 (10) , 5838-5847
Abstract
A 4-GHz phase-locked loop (PLL) incorporating an on-chip phase noise (PN) measurement circuit and a voltage-controlled oscillator (VCO) using an array of cross-coupled transistor pairs that can be configured using intelligent post-fabrication selection is reported. The cross-coupled pairs employ transistors with dimensions near the minimum for the process, and the post-fabrication configuration lowers its PN. The selection reduces the PLL PN at a 1-MHz offset from a 4-GHz carrier by $\sim$ 3.8 dB from the worst. The PN measurement circuit not requiring an external surface acoustic wave (SAW) filter was used to measure PN of $\sim$ $-$ 119 and $-$ 128 dBc/Hz at 1-and 2-MHz offsets, respectively. These are 2–3 dB lower compared to the lowest measured using on-chip PN measurement circuits in the literature. The maximum PN measurement circuit error at 1-MHz offset is 1.2 dB compared to signal source analyzer (E5052B) measurements. After high voltage stress that degrades PN, the performance was recovered by reselection, indicating that this design approach should also allow an increase in the VCO lifetime. This circuit is fabricated in a 65-nm CMOS technology with a chip area of 1 $\times$ 1.5 mm. The on-chip PN measurement circuit consumes 7.5 mW of dc power. This work suggests that designing for the best performance rather than the conventional approach of designing for the worst can be made practical.Keywords
Funding Information
- Semiconductor Research Corporation through Texas Analog Center of Excellence (2810.077)
- SRC through the TxACE, The University of Texas at Dallas (2712.025)
This publication has 20 references indexed in Scilit:
- IEEE Standard Definitions of Physical Quantities for Fundamental Frequency and Time Metrology--Random Instabilities2022
- An 8-bit 1.5GS/s flash ADC using post-manufacturing statistical selection2010
- Digital Detection of Oxide Breakdown and Life-Time Extension in Submicron CMOS TechnologyIEEE International Solid-State Circuits Conference, 2008
- A Digitally Controlled Oscillator System for SAW-Less Transmitters in Cellular HandsetsIEEE Journal of Solid-State Circuits, 2006
- The Design of CMOS Radio-Frequency Integrated Circuits2003
- A fully integrated 1.5-V 5.5-GHz CMOS phase-locked loopIEEE Journal of Solid-State Circuits, 2002
- SOI and bulk CMOS frequency dividers operatingabove 15 GHzElectronics Letters, 2001
- Fully integrated 5.35-GHz CMOS VCOs and prescalersIEEE Transactions on Microwave Theory and Techniques, 2001
- Charge pump with perfect current matchingcharacteristics in phase-locked loopsElectronics Letters, 2000
- Cell-based fully integrated CMOS frequency synthesizersIEEE Journal of Solid-State Circuits, 1994