Topology identification of electronic mass-market equipment for estimation of lifetime reduction by HF disturbances above 2 kHz
Authors:
- 1 June 2017
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-6
Abstract
In order to assess the lifetime reduction of electronic equipment caused by high frequency (HF) distortion in the grid, a method is presented to identify circuit topologies of typical household devices only by measurements. The procedure is explained by laboratory measurements of two devices. Based on this method, the circuit topologies will be analyzed for built-in components that are stressed by HF disturbances in the frequency range of 2 kHz to 150 kHz. Therefore, three main topologies for household devices are described and the influence of the HF disturbances on these topologies is derived. Additionally, taking account of the HF disturbances, the aging of electrolytic capacitors as an example for stressed built-in components is described and calculated based on laboratory measurements of another household device and the setup of a test platform for aging experiments is presented.Keywords
This publication has 8 references indexed in Scilit:
- Emission levels above 2 kHz - Laboratory results and survey measurements in public low voltage grids2013
- Impact of higher frequency emission above 2kHz on electronic mass-market equipment2013
- Power quality challenges in future distribution networks2011
- Frequencies above the harmonic range - challenge of the future?2010
- Thermal modeling of aluminum electrolytic capacitors2003
- Influence of aging on electrolytic capacitors function in static converters: Fault prediction methodThe European Physical Journal Applied Physics, 1999
- Failure prediction of electrolytic capacitors during operation of a switchmode power supplyIEEE Transactions on Power Electronics, 1998
- Use of ESR for deterioration diagnosis of electrolytic capacitorIEEE Transactions on Power Electronics, 1993