Encapsulation and backsheet adhesion metrology for photovoltaic modules
- 26 September 2016
- journal article
- research article
- Published by Wiley in Progress in Photovoltaics: Research and Applications
- Vol. 25 (1) , 87-96
Abstract
Photovoltaic modules are designed to operate for decades in terrestrial environments. However, mechanical stress, moisture, and ultraviolet radiation eventually degrade protective materials in modules, particularly their adhesion properties, eventually leading to reduced solar cell performance. Despite the significance of interfacial adhesion to module durability, currently there is no reliable technique for characterizing module adhesion properties. We present a simple and reproducible metrology for characterizing adhesion in photovoltaic modules that is grounded in fundamental concepts of beam and fracture mechanics. Using width‐tapered cantilever beam fracture specimens, interfacial adhesion was evaluated on relevant interfaces of encapsulation and backsheet structures of new and 27‐year‐old historic modules. The adhesion energy, Gc [J/m2], was calculated from the critical value of the strain energy release rate, G, using G = βP2, where β (a mechanical and geometric parameter of the fracture specimen) and P (the experimentally measured critical load) are constants. Under some circumstances where testing may result in cracking of brittle layers in the test specimen, measurement of the delamination length in addition to the critical load was necessary to determine G. Relative to new module materials, backsheet adhesion was 95% and 98% lower for historic modules that were exposed (operated in the field) and unexposed (stored on‐site, but out of direct sunlight), respectively. Encapsulation adhesion was 87–94% lower in the exposed modules and 31% lower in the unexposed module. The metrology presented here can be used to improve module materials and assess long‐term reliability. Copyright © 2016 John Wiley & Sons, Ltd.Keywords
Funding Information
- U.S. Department of Energy (DE‐AC36‐08GO28308)
This publication has 29 references indexed in Scilit:
- A parametric study of the peel testInternational Journal of Adhesion and Adhesives, 2008
- Moisture transport, adhesion, and corrosion protection of PV module packaging materialsSolar Energy Materials and Solar Cells, 2006
- Experimental studies of Mode I energy release rate in adhesively bonded width tapered composite DCB specimensComposites Science and Technology, 2005
- Effect of matrix cracking in cross-ply ceramic matrix composite beams on their mechanical properties and natural frequenciesInternational Journal of Non-Linear Mechanics, 2003
- A Triangular Double Cantilever Beam Test for Measuring Adhesive or Cohesive Fracture EnergyThe Journal of Adhesion, 1992
- Theory of stress transfer in a 0°—90°—0° cross-ply laminate containing a parallel array of transverse cracksJournal of the Mechanics and Physics of Solids, 1992
- Interlaminar Fracture Behavior and Fiber Bridging of Glass-Epoxy Composite Under Mode I Static and Cyclic LoadingsJournal of Composite Materials, 1989
- Mechanics of the Peel Test for Thin Film AdhesionMRS Proceedings, 1988
- A Comparison of Fracture Toughness of Matrix Controlled Failure Modes: Delamination and Transverse CrackingJournal of Composite Materials, 1986
- Peel adhesion. I. Some phenomenological aspects of the testJournal of Applied Polymer Science, 1963