A modeling approach to the effect of resin characteristics on parison formation in extrusion blow molding
- 18 November 2008
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 49 (2) , 251-263
Abstract
The most critical stage in the extrusion blow‐molding process is the parison formation, as the dimensions of the blow‐molded part are directly related to the parison dimensions. The swelling due to stress relaxation and sagging due to gravity are strongly influenced by the resin characteristics, die geometry, and operating conditions. These factors significantly affect the parison dimensions. This could lead to a considerable amount of time and cost through trial and error experiments to get the desired parison dimensions based upon variations in the resin characteristics, die geometry, and operating conditions. The availability of a modeling technique ensures a more accurate prediction of the entire blow‐molding process, as the proper prediction of the parison formation is the input for the remaining process phases. This study considers both the simulated and the experimental effects of various high‐density polyethylene resin grades on parison dimensions. The resins were tested using three different sets of die geometries and operating conditions. The target parison length was achieved by adjusting the extrusion time for a preset die gap opening. The finite element software BlowParison® was used to predict the parison formation, taking into account the swell and sag. Good agreements were found between the predicted parison dimensions and the experimental data. POLYM. ENG. SCI., 2009. Published by Society of Plastics EngineersKeywords
This publication has 33 references indexed in Scilit:
- The effect of molar mass distribution on extrudate swell of linear polymersJournal of Non-Newtonian Fluid Mechanics, 2008
- Annular extrudate swell of pseudoplastic and viscoplastic fluidsJournal of Non-Newtonian Fluid Mechanics, 2007
- Prediction of parison swell in plastics extrusion blow molding using a neural network methodPolymer Testing, 2002
- Current issues in non-Newtonian flows: a mathematical perspectiveJournal of Non-Newtonian Fluid Mechanics, 2000
- High-order finite element methods for steady viscoelastic flowsJournal of Non-Newtonian Fluid Mechanics, 1995
- Flow simulation of herschel‐bulkley fluids through extrusion diesThe Canadian Journal of Chemical Engineering, 1993
- Extrudate swell of high density polyethylene. Part II: Time dependency and effects of cooling and saggingPolymer Engineering & Science, 1992
- Effect of molecular weight distribution on viscoelastic properties of polymers. 2. Terminal relaxation time and steady-state complianceMacromolecules, 1984
- Numerical Methods in Non-Newtonian Fluid MechanicsAnnual Review of Fluid Mechanics, 1983
- The Temperature Dependence of Relaxation Mechanisms in Amorphous Polymers and Other Glass-forming LiquidsJournal of the American Chemical Society, 1955