An integrated 8A pulsed VCSEL array driver under 12V supply with built-in pulse monitor and automatic peak current control for direct time-of-flight applications
Authors:
- 7 November 2021
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-3
Abstract
Direct time-of-flight (DToF) has become a prominent depth-sensing technique used in light detection and ranging (LiDAR) systems for consumer, industrial, and automotive applications. Compared with scanning LiDAR, flash LiDAR eliminates mechanical moving parts and MEMS mirrors, making compact solid-state LiDAR systems available with high reliability and low cost [1]. Fig. 1(a) illustrates a solid-state flash DToF system consisting of a single photon avalanche diode (SPAD)-based receiver sensor, a high-power pulsed laser-diode driver (LDD), and a vertical cavity surface-emitting laser (VCSEL) array as the laser source. To detect longer range within power consumption constraints, short laser pulses with high peak power are required. Several integrated pulsed LDDs have been reported in recent years, but they either have over 50V supply voltage and un-programmable pulse width [2] [3], or 500mA low modulation current [4]. This work presents an integrated VCSEL array driver generating over 8A maximum peak current using a 12V supply, producing laser pulses up to 20.3W peak power, 120ps rise time, and down to 276ps full-width at half-maximum (FWHM).Keywords
This publication has 3 references indexed in Scilit:
- Modeling and Analysis of a Direct Time-of-Flight Sensor Architecture for LiDAR ApplicationsSensors, 2019
- A Sub-ns Integrated CMOS Laser Driver With Configurable Laser Pulses for Time-of-Flight ApplicationsIEEE Sensors Journal, 2018
- A High Repetition Rate CMOS Driver for High-Energy Sub-ns Laser Pulse Generation in SPAD-Based Time-of-Flight Range FindingIEEE Sensors Journal, 2015