Parameter Reduction of Composite Load Model Using Active Subspace Method
- 10 May 2021
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Systems
- Vol. 36 (6) , 5441-5452
Abstract
Over the past decades, the increasing penetration of distributed energy resources (DERs) has dramatically changed the power load composition in the distribution networks. The traditional static and dynamic load models can hardly capture the dynamic behavior of modern loads especially for fault-induced delayed voltage recovery (FIDVR) events. Thus, a more comprehensive composite load model with combination of static load, different types of induction motors, single-phase A/C motor, electronic load and DERs has been proposed by Western Electricity Coordinating Council (WECC). However, due to the large number of parameters and model complexity, the WECC composite load model (WECC CMLD) raises new challenges to power system studies. To overcome these challenges, in this paper, a cutting-edge parameter reduction (PR) approach for WECC CMLD based on active subspace method (ASM) is proposed. Firstly, the WECC CMLD is parameterized in a discrete-time manner for the application of the proposed method. Then, parameter sensitivities are calculated by discovering the active subspace, which is a lower-dimensional linear subspace of the parameter space of WECC CMLD in which the dynamic response is most sensitive. The interdependency among parameters can be taken into consideration by our approach. Finally, the numerical experiments validate the effectiveness and advantages of the proposed approach for WECC CMLD model.Keywords
Funding Information
- Advanced Grid Modeling Program
- U.S. Department of Energy Office of Electricity (DE-OE0000875)
- National Science Foundation
- Division of Civil, Mechanical and Manufacturing Innovation (1745451)
This publication has 24 references indexed in Scilit:
- Bias correction for the estimation of sensitivity indices based on random balance designsReliability Engineering & System Safety, 2012
- How to avoid a perfunctory sensitivity analysisEnvironmental Modelling & Software, 2010
- Variance based sensitivity analysis of model output. Design and estimator for the total sensitivity indexComputer Physics Communications, 2010
- A methodology for performing global uncertainty and sensitivity analysis in systems biologyJournal of Theoretical Biology, 2008
- Global sensitivity indices for nonlinear mathematical models and their Monte Carlo estimatesMathematics and Computers in Simulation, 2001
- An alternative way to compute Fourier amplitude sensitivity test (FAST)Computational Statistics & Data Analysis, 1998
- Searching for important factors in simulation models with many factors: Sequential bifurcationEuropean Journal of Operational Research, 1997
- Importance measures in global sensitivity analysis of nonlinear modelsReliability Engineering & System Safety, 1996
- A New Class of Supersaturated DesignsTechnometrics, 1993
- Factorial Sampling Plans for Preliminary Computational ExperimentsTechnometrics, 1991