Energy characterization of sawwood generated from mechanical processing of wood in small-scale sawmills
Authors:
- Irlan Paulo Ferreira CampeloICIrlan Paulo Ferreira Campelo
- Renato Nogueira AntasRARenato Nogueira Antas
- Elaine Cristina Alves da SilvaESElaine Cristina Alves da Silva
- Cleyton dos Santos SouzaCSCleyton dos Santos Souza
- Juliana Cristina Rodrigues AraújoJAJuliana Cristina Rodrigues Araújo
- Larissa de Medeiros AraújoLALarissa de Medeiros Araújo
- Eliane Cristina Sampaio de FreitasEFEliane Cristina Sampaio de Freitas
- Rafael Leite BrazRBRafael Leite Braz
Open Access
- 22 September 2026
- journal article
- research article
- Published by Springer Nature in Journal of the Indian Academy of Wood Science
- Vol. 23 (2) , 502-510
Abstract
The growing demand for renewable energy sources has stimulated interest in biomass as a sustainable alternative, particularly the use of residues from the wood-processing industry. This study evaluated the energy potential of sawdust from two tropical hardwood species—maçaranduba ( Manilkara spp.) and sucupira ( Bowdichia spp.)—sourced from small-scale sawmills in Camaragibe, Pernambuco, Brazil. The samples underwent analyses for moisture content, bulk density, proximate composition (volatile matter, fixed carbon, and ash), structural chemical composition (extractives, lignin, and holocellulose), and calorific parameters, following standardized protocols (ASTM, NBR, and TAPPI). Beyond reporting conventional fuel properties, the study interprets these results from an application-oriented perspective for decentralized bioenergy use. Both residues exhibited favorable energy characteristics, including high calorific value and high volatile matter content. Maçaranduba showed slightly higher gross calorific value and markedly lower ash content, whereas sucupira presented lower moisture content and, consequently, a 3.5% higher useful heating value. Derived indicators showed that both residues had very similar useful volumetric energy density (approximately 2.4 GJ m −3 ), while sucupira would generate substantially more ash per unit of useful energy than maçaranduba. These results indicate that the two residues are suitable for thermal valorization but are not operationally interchangeable: sucupira is more attractive where lower as-received moisture is advantageous, whereas maçaranduba is more favorable where lower ash generation and reduced ash-management demand are priorities. Thus, the study contributes by translating standard physicochemical characterization into route-selection criteria relevant to small-scale sawmill bioenergy systems.Keywords
Funding Information
- Universidade Federal Rural de Pernambuco
This publication has 25 references indexed in Scilit:
- Effect of contrasting climatic conditions in Brazil on heartwood and sapwood production and chemistry in young Eucalyptus clonesEuropean Journal of Forest Research, 2026
- Optimization and characterization of hybrid bio-briquettes produced from the mixture of sawdust, sugarcane bagasse, and paddy strawEnvironmental Science and Pollution Research, 2024
- Diversity of properties of sawmill residues used as feedstock for energy generationRenewable Energy, 2022
- Cleaner energy potential analysis for composite biomass residues from decentralized sawmills in Ghana- A case study for Oforikrom MunicipalityCleaner Engineering and Technology, 2022
- Energy from planted forest and its residues characterization in BrazilEnergy, 2022
- Assessment of the potential of charred briquettes of sawdust, rice and coconut husks: Using water boiling and user acceptability testsScientific African, 2021
- Correlation Coefficients: Appropriate Use and InterpretationAnesthesia & Analgesia, 2018
- Effect of species, particle size and compacting pressure on relaxed density and compressive strength of fuel briquettesInternational Journal of Energy and Environmental Engineering, 2013
- RESÍDUOS DE INDÚSTRIA MADEIREIRA: CARACTERIZAÇÃO, CONSEQUÊNCIAS SOBRE O MEIO AMBIENTE E OPÇÕES DE USOHolos Environment, 2006
- A correlation for calculating HHV from proximate analysis of solid fuelsFuel, 2005