Microstructure and Properties of Ti Rods Produced by Multi-Step SPD
- 15 January 2006
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 503-504, 763-768
Abstract
This paper studies the effect of combined SPD treatment on microstructure and mechanical properties of semi-products out of CP Ti. The combined processing, consisting of equal-channel angular pressing and further thermomechanical treatment, produced ultrafine-grained rods out of Grade 2 CP Ti with a diameter of 6.5 mm and a length of up to 1 m. It was established that the formation of homogeneous ultrafine-grained structure in Ti rod with α-grain size of about 100 nm allowed to enhance yield stress by 200% in comparison with initial annealed state.Keywords
This publication has 9 references indexed in Scilit:
- Microstructure and Mechanical Properties of Long, Ultrafine-Grained Ti Rods2006
- Nanostructuring of metals by severe plastic deformation for advanced propertiesNature Materials, 2004
- Nanostructures in Ti processed by severe plastic deformationJournal of Materials Research, 2003
- Advanced mechanical properties of pure titanium with ultrafine grained structureScripta Materialia, 2001
- Microstructure and properties of pure Ti processed by ECAP and cold extrusionMaterials Science and Engineering: A, 2001
- Influence of ECAP routes on the microstructure and properties of pure TiMaterials Science and Engineering: A, 2001
- Titanium in Medicine2001
- Enhanced superplasticity in a Ti-6Al-4V alloy processed by severe plastic deformationScripta Materialia, 2000
- Bulk nanostructured materials from severe plastic deformationProgress in Materials Science, 2000