Electrochemical Behavior of Al–Al9Co2 Alloys in Sulfuric Acid
Open Access
- 5 August 2020
- journal article
- research article
- Published by MDPI AG in Corrosion and Materials Degradation
- Vol. 1 (2) , 249-272
Abstract
Al–Co alloys of various Co contents (2–20 wt.% Co) were fabricated by vacuum arc melting (VAM) with the scope to investigate the influence of cobalt on the microstructure and corrosion resistance of Al in 1 M H2SO4. The obtained microstructures were directional, consisting of Al9Co2 platelets (grown to coarse acicular plates as the Co content increased) uniformly dispersed in an Al-matrix. Alloying Al with Co did not decrease the rate of uniform corrosion of Al but it considerably increased its passivation ability. Moreover, all Al–Co alloys displayed lower uniform corrosion rate and notably higher passivation ability than market leading Al-alloys. The underlying mechanisms during anodic polarization in 1 M H2SO4 were identified and correlated with the microstructure. High Co content alloys (7–20 wt.% Co) presented superior passivation ability in 1 M H2SO4 as compared to the low Co content alloys.Keywords
This publication has 80 references indexed in Scilit:
- Analysis of Crystallization Process of Intensive Cooled AlSi20CuNiCoMg AlloyArchives of Foundry Engineering, 2017
- Effect of Cooling Rate on Microstructure and Grain Refining Behavior of In Situ CeB6/Al Composite Inoculant in AluminumMetals, 2017
- Influence of cooling rate on the microstructure and corrosion behavior of Al–Fe alloysCorrosion Science, 2015
- The quantitative relationship between microstructure and mechanical property of a melt spun Al–Mg alloyMaterials Science and Engineering: A, 2015
- Effect of Ti, Zr and Hf addition on microstructure and properties of rapidly solidified Al–Mn–Fe alloyJournal of Alloys and Compounds, 2014
- Preparation and Structural Characterization of Rapidly Solidified Al–Cu AlloysJournal of Materials Science & Technology, 2014
- Structural investigations of mechanical properties of Al based rapidly solidified alloysMaterials & Design (1980-2015), 2011
- Amorphous and crystalline phases in rapidly solidified Al–Ta and Al–Ta–V alloysJournal of Alloys and Compounds, 2007
- Rapidly solidified Al–6.5 wt.% Ni alloyJournal of Materials Processing Technology, 2003
- Metallography of a melt-quenched aluminum-cobalt alloyMetallography, 1988