Mechanical and rheological properties of carbon black filled polyethylene
Authors:
- 1 December 1988
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 9 (6) , 412-418
Abstract
The mechanical and rheological properties of high density polyethylene filled with carbon black have been examined. Two sources of carbon black (one commercial and other obtained from a pyrolysis process) and various treatments have been studied. The rheological measurements in the melt state has been performed on a Rheometrics stress rheometer and a capillary rheometer. These materials possess outstanding hardness and toughness showing great potential for structural application. Comparison of carbon black from two sources showed that the carbon from the pyrolysis process has a good potential as a reinforcing agent. It was found that surface treatment reduces the particle‐particle interactions and improves the filler dispersion. The relationship between the yield stresses, filler percentage, surface modification by the coupling agents and mechanical properties is discussed.Keywords
This publication has 27 references indexed in Scilit:
- Modelling of Shear Viscosity Behavior and Extrusion through Dies for Rubber CompoundsRubber Chemistry and Technology, 1987
- Poly(aryl‐ether‐ether‐ketone) and its advanced composites: A reviewPolymer Composites, 1987
- Flow patterns in carbon black filled polyethylene at the entrance to a dieJournal of Non-Newtonian Fluid Mechanics, 1985
- A Wide‐angle X‐ray diffraction method of determining chopped fiber orientation in composites with application to extrusion through diesPolymer Engineering & Science, 1984
- A Comparative Rheological Investigation of Natural and Synthetic Cis-1,4 Polyisoprenes and Their Carbon Black CompoundsRubber Chemistry and Technology, 1982
- Tensile strength of filled polymersJournal of Polymer Science: Polymer Physics Edition, 1982
- Experimental Studies of the Influence of Particle and Fiber Reinforcement on the Rheological Properties of Polymer MeltsRubber Chemistry and Technology, 1980
- Experimental investigations of shear and elongational flow properties of polystyrene melts reinforced with calcium carbonate, titanium dioxide, and carbon blackPolymer Engineering & Science, 1980
- An experimental study of the influence of carbon black on the rheological properties of a polystyrene meltPolymer Engineering & Science, 1979
- Engineering potential of composite materialsPolymer Engineering & Science, 1975