Microstructure and mechanical properties of a large billet of spray formed Al–Zn–Mg–Cu alloy with high Zn content
Authors:
- Pucun BaiPBPucun Bai
- Xiaohu HouXHXiaohu Hou
- Xiuyun ZhangXZXiuyun Zhang
- Chunwang ZhaoCZChunwang Zhao
- Yongming XingYXYongming Xing
- 1 May 2009
- journal article
- Published by Elsevier in Materials Science and Engineering: A
- Vol. 508 (1-2) , 23-27
Abstract
No abstract availableThis publication has 17 references indexed in Scilit:
- Effect of heat treatment on the microstructure and mechanical properties of the spray-deposited Al–10.8Zn–2.8Mg–1.9Cu alloyMaterials Science and Engineering: A, 2008
- Microstructure and mechanical properties of spray-deposited Al–Zn–Mg–Cu alloyMaterials & Design (1980-2015), 2007
- Microstructure and mechanical properties of spray-deposited Al–10.8Zn–2.8Mg–1.9Cu alloy after two-step aging treatment at 110 and 150 °CMaterials Characterization, 2007
- Hardening mechanisms of spray formed Al–Zn–Mg–Cu alloys with scandium and other elemental additionsJournal of Alloys and Compounds, 2006
- Microstructural evolution in a spray-cast aluminum alloy during equal-channel angular pressingMaterials Science and Engineering: A, 2005
- Mesoscopic structure control of spray formed high strength Al–Zn–Mg–Cu alloysActa Materialia, 2005
- Influence of ECAP on precipitate distributions in a spray-cast aluminum alloyActa Materialia, 2005
- Early-stage precipitation in Al–Zn–Mg–Cu alloy (7050)Acta Materialia, 2004
- Creep behavior of spray-cast 7XXX aluminum alloyMaterials & Design (1980-2015), 2002
- Microstructural and mechanical evaluations of spray-deposited 7XXX Al-alloys after conventional consolidationMaterials Science and Engineering: A, 1994