Low temperature needle like mullite grain formation in sol–gel precursors coated on SiC porous substrates
Authors:
- M. JayasankarMJM. Jayasankar
- G.M. AnilkumarGAG.M. Anilkumar
- V.S. SmithaVSV.S. Smitha
- P. MukundanPMP. Mukundan
- C.D. MadhusoodanaCMC.D. Madhusoodana
- K.G.K. WarrierKWK.G.K. Warrier
- 1 September 2011
- journal article
- Published by Elsevier in Thin Solid Films
- Vol. 519 (22) , 7672-7676
Abstract
No abstract availableKeywords
This publication has 22 references indexed in Scilit:
- Microstructural, mechanical and thermal characterisation of sol–gel-derived aluminium titanate–mullite ceramic compositesActa Materialia, 2006
- CVD mullite and mullite-alumina corrosion protection coatings for silicon based ceramicsJournal de Physique IV, 2001
- Novel Low‐Temperature Processing Route of Dense Mullite Ceramics by Reaction Sintering of Amorphous SiO2‐Coated γ‐Al2O3 Particle NanocompositesJournal of the American Ceramic Society, 1999
- Effect of seeds on the formation of sol-gel mulliteCeramics International, 1997
- Corrosion of Silicon‐Based Ceramics in Combustion EnvironmentsJournal of the American Ceramic Society, 1993
- Fabrication of Mullite and Mullite‐Matrix Composites by Transient Viscous Sintering of Composite PowdersJournal of the American Ceramic Society, 1991
- Some New Perspectives on Oxidation of Silicon Carbide and Silicon NitrideJournal of the American Ceramic Society, 1991
- Thermal Expansion of MulliteJournal of the American Ceramic Society, 1990
- Oxidation Kinetics of Silicon Carbide Crystals and Ceramics: I, In Dry OxygenJournal of the American Ceramic Society, 1986
- High‐Temperature Mechanical Properties of Mullite Under CompressionJournal of the American Ceramic Society, 1977