Fabrication and Physical Evaluation of Gelatin-Coated Carbonate Apatite Foam
Open Access
Abstract
Carbonate apatite (CO3Ap) foam has gained much attention in recent years because of its ability to rapidly replace bone. However, its mechanical strength is extremely low for clinical use. In this study, to understand the potential of gelatin-reinforced CO3Ap foam for bone replacement, CO3Ap foam was reinforced with gelatin and the resulting physical characteristics were evaluated. The mechanical strength increased significantly with the gelatin reinforcement. The compressive strength of gelatin-free CO3Ap foam was 74 kPa whereas that of the gelatin-reinforced CO3Ap foam, fabricated using 30 mass % gelatin solution, was approximately 3 MPa. Heat treatment for crosslinking gelatin had little effect on the mechanical strength of the foam. The gelatin-reinforced foam did not maintain its shape when immersed in a saline solution as this promoted swelling of the gelatin; however, in the same conditions, the heat-treated gelatin-reinforced foam proved to be stable. It is concluded, therefore, that heat treatment is the key to the fabrication of stable gelatin-reinforced CO3Ap foam.Keywords
Funding Information
- Japan Agency for Medical Research and Development, and Grant-in-Aids for Scientific Research (25463137, 24592989)
This publication has 25 references indexed in Scilit:
- Gelatin-layered and multi-sized porous β-tricalcium phosphate for tissue engineering scaffoldDiscover Nano, 2012
- Enzymatically crosslinked porous composite matrices for bone tissue regenerationJournal of Biomedical Materials Research Part A, 2009
- Porous scaffold of gelatin–starch with nanohydroxyapatite composite processed via novel microwave vacuum dryingActa Biomaterialia, 2008
- Fabrication of low‐crystallinity hydroxyapatite foam based on the setting reaction of α‐tricalcium phosphate foamJournal of Biomedical Materials Research Part A, 2008
- Fabrication of macroporous carbonate apatite foam by hydrothermal conversion of α‐tricalcium phosphate in carbonate solutionsJournal of Biomedical Materials Research Part A, 2008
- Effects of Sintering Temperature Over 1,300.DEG.C. on the Physical and Compositional Properties of Porous Hydroxyapatite FoamDental Materials Journal, 2006
- Enzymatic stabilization of gelatin‐based scaffoldsJournal of Biomedical Materials Research Part B: Applied Biomaterials, 2004
- Development of a calcium phosphate–gelatin composite as a bone substitute and its use in drug releaseBiomaterials, 1999
- Cross‐Linking of Gelatin Capsules and Its Relevance to Their in Vitro-in Vivo PerformanceJournal of Pharmaceutical Sciences, 1994
- Collagen engineering for biomaterial useClinical Materials, 1992