An empirical study of the wound effect on sap flux density measured with thermal dissipation probes
Open Access
- 1 September 2016
- journal article
- research article
- Published by Oxford University Press (OUP) in Tree Physiology
- Vol. 36 (12) , 1471-1484
Abstract
The insertion of thermal dissipation (TD) sensors on tree stems for sap flux density (SFD) measurements can lead to SFD underestimations due to a wound formation close to the drill hole. However, the wound effect has not been assessed experimentally for this method yet. Here, we propose an empirical approach to investigate the effect of the wound healing on measured sap flux with TD probes. The approach was performed for both, diffuse-porous (Fagus sylvatica (Linnaeus)) and ring-porous (Quercus petraea (Lieblein)) species. Thermal dissipation probes were installed on different dates along the growing season to document the effects of the dynamic wound formation. The trees were cut in autumn and additional sensors were installed in the cut stems, therefore, without potential effects of wound development. A range of water pressures was applied to the stem segments and SFDs were simultaneously measured by TD sensors as well as gravimetrically in the laboratory. The formation of wounds around sensors installed in living tree stems led to underestimation of SFD by 21.4 ± 3 and 47.5 ± 3.8% in beech and oak, respectively. The differences between SFD underestimations of diffuse-porous beech and ring-porous oak were, however, not statistically significant. Sensors with 5-, 11- and 22-week-old wounds also showed no significant differences, which implies that the influence of wound formation on SFD estimates was completed within the first few weeks after perforation. These results were confirmed by time courses of SFD measurements in the field. Field SFD values decreased immediately after sensor installation and reached stable values after ~2 weeks with similar underestimations to the ones observed in the laboratory. We therefore propose a feasible approach to correct directly field observations of SFD for potential underestimations due to the wound effect.Keywords
Funding Information
- German Federal Ministry of Education and Research (03 IS 2001A)
- Ministry of Economy, Innovation, Science and Employment (291780)
This publication has 54 references indexed in Scilit:
- Relationships between canopy transpiration, atmospheric conditions and soil water availability—Analyses of long-term sap-flow measurements in an old Norway spruce forest at the Ore Mountains/GermanyAgricultural and Forest Meteorology, 2011
- Calibration of thermal dissipation sap flow probes for ring- and diffuse-porous treesTree Physiology, 2010
- The effects of Phytophthora ramorum infection on hydraulic conductivity and tylosis formation in tanoak sapwoodCanadian Journal of Forest Research, 2009
- Using branch and basal trunk sap flow measurements to estimate whole-plant water capacitance: a cautionPlant and Soil, 2007
- Plant–water relations and the fibre saturation pointNew Phytologist, 2005
- Potential errors in measurement of nonuniform sap flow using heat dissipation probesTree Physiology, 1999
- Evaluation of the heat pulse velocity technique for measurement of sap flow in rainforest and eucalypt forest species of south‐eastern AustraliaPlant, Cell & Environment, 1995
- Xylem dysfunction in Quercus: vessel sizes, tyloses, cavitation and seasonal changes in embolismTree Physiology, 1990
- Occurrence and Location of Suberin in Wound Reaction Zones in Xylem of 17 Tree SpeciesPhytopathology®, 1987
- Improvement of the heat pulse method for determining sap flow in treesPlant, Cell & Environment, 1981