First-Principles Study of the Structural, Mechanical and Thermodynamic Properties of Al11RE3 in Aluminum Alloys
Open Access
Abstract
The stability and mechanical and thermodynamic properties of Al11RE3 intermetallics (RE = Sc, Y and lanthanide La-Lu) have been investigated by combining first-principles and Debye model calculations. It was found that the formation enthalpies of the Al11RE3 intermetallics are all negative, indicating that they are stable; moreover, the experimental values of Al11La3 and Al11Ce3 are in good agreement with the predicted values, which are −0.40 kJ/mol and −0.38 kJ/mol, respectively. The calculated results of the mechanical properties reveal that the Young’s modulus E and shear modulus G of Al11RE3 (RE = La, Ce, Pr, Nd and Sm) intermetallics are obviously greater than that of Al, implying that the stiffness, toughness, and tensile strength of them are significantly greater than those of aluminum, and that they, as strengthen phases, can effectively improve the mechanical property of aluminum alloys. The Poisson’s ratio v of Al11Sc3 (0.37) is the largest, and the heterogeneity is obvious. All the Al11RE3 intermetallics can enhance the thermostability of the aluminum because of their lower Gibbs free energy F in the range of −5.002~−4.137 eV/atom and thermal expansion coefficient α of Al in the range of 2.34~2.89 × 10−5/K at 300K, as well as higher entropy and constant volume-specific heat than aluminum at finite temperatures. With an increase in the atomic number, different change trends were observed for the formation enthalpy ΔHf, bulk modulus B, Young’s modulus E, and shear modulus G. This paper can provide ideas and help for designing a high-performance, heat-resistant aluminum alloy.Keywords
Funding Information
- R & D plan for key areas in Guangdong Province (2020B010186001, 2020B1515120093, 20201BBE51009, HQ21016, 21A0564, HP21047, 2022CE024, 52171115)
- R & D plan for key areas in Jiangxi Province (2020B010186001, 2020B1515120093, 20201BBE51009, HQ21016, 21A0564, HP21047, 2022CE024, 52171115)
- Scientific research project of Hunan Institute of Technology (2020B010186001, 2020B1515120093, 20201BBE51009, HQ21016, 21A0564, HP21047, 2022CE024, 52171115)
- National Natural Science Foundation of China (2020B010186001, 2020B1515120093, 20201BBE51009, HQ21016, 21A0564, HP21047, 2022CE024, 52171115)
This publication has 55 references indexed in Scilit:
- Microstructure of diphase dendrite in Al–35%La alloy during solidificationJournal of Crystal Growth, 2013
- First-principles study of the nucleation and stability of ordered precipitates in ternary Al–Sc–Li alloysActa Materialia, 2011
- First-principles phase stability, magnetic properties and solubility in aluminum–rare-earth (Al–RE) alloys and compoundsActa Materialia, 2011
- High-pressure phase relations in the composition of albite NaAlSi3O8 constrained by an ab initio and quasi-harmonic Debye model, and their implicationsEarth and Planetary Science Letters, 2010
- Effect of substituting cerium-rich mischmetal with lanthanum on microstructure and mechanical properties of die-cast Mg–Al–RE alloysMaterials & Design (1980-2015), 2009
- From ultrasoft pseudopotentials to the projector augmented-wave methodPhysical Review B, 1999
- Improved tetrahedron method for Brillouin-zone integrationsPhysical Review B, 1994
- Development of the Colle-Salvetti correlation-energy formula into a functional of the electron densityPhysical Review B, 1988
- Special points for Brillouin-zone integrationsPhysical Review B, 1976
- Forces in MoleculesPhysical Review B, 1939