On the Optimization of Roughness and Corrosion Resistance of Laser Beam Powder Bed Fusion Fabricated Ti–6Al–4V Parts—An Electrochemical Approach
Authors:
Open Access
- 1 October 2024
- journal article
- research article
- Published by Wiley in Advanced Engineering Materials
- Vol. 26 (23)
Abstract
Laser beam powder bed fusion is emerging as a technology for fabricating components made of advanced alloys, such as Ti–6Al–4V. However, it suffers from rough as‐built (AB) surfaces, necessitating postprocessing for desired quality and performance. Electrochemical methods such as electrochemical polishing (ECP) and anodization (AN) are promising postprocessing methods; ECP can effectively smoothen surfaces irrespective of their complexity and hardness, while AN enhances the material's corrosion resistance. However, literature lacks research that discusses combined ECP and AN treatment on surface texture evaluation and corrosion behavior. This work presents a detailed study on the effects of different processing factor levels using a Taguchi design of experiment (DOE) approach and discusses the underlying process mechanisms. The optimized treatment conditions to achieve highest roughness improvement and best corrosion resistance are discussed and the most influential postprocessing factors are revealed and ranked. The treatment that achieved smooth surfaces and high corrosion resistance is ECP at 20 V and 15 °C for 20 min, followed by AN at 15 V for 5 min. This treatment achieves a 72% roughness improvement, providing an arithmetic areal surface roughness of 2.63 μm and a corrosion current density of 0.09 μA cm−2, which is almost similar to the AB part.Keywords
Funding Information
- Natural Sciences and Engineering Research Council of Canada (RGPIN‐2019‐05973)
This publication has 61 references indexed in Scilit:
- On the Post‐Processing of Complex Additive Manufactured Metallic Parts: A ReviewAdvanced Engineering Materials, 2024
- Electropolishing and anodization of titanium in water/ethylene glycol baths for the production of TiO2 nanotubesJournal of Nanoparticle Research, 2020
- Investigation of electrochemical post-processing procedure for Ti-6Al-4V lattice structure manufactured by direct metal laser sintering (DMLS)The International Journal of Advanced Manufacturing Technology, 2019
- Anodization of titanium alloys for orthopedic applicationsFrontiers of Chemical Science and Engineering, 2018
- Electropolishing of Re-melted SLM Stainless Steel 316L Parts Using Deep Eutectic Solvents: 3 × 3 Full Factorial DesignJournal of Materials Engineering and Performance, 2016
- Surface Modification of Ti6Al4V Open Porous Structures Produced by Additive ManufacturingAdvanced Engineering Materials, 2012
- Influence of process parameters on part quality and mechanical properties for DMLS and SLM with iron-based materialsThe International Journal of Advanced Manufacturing Technology, 2011
- Pure Commercial Titanium Color Anodizing and Corrosion ResistanceJournal of Materials Engineering and Performance, 2011
- Interference colors of thin oxide layers on titaniumColor Research & Application, 2008
- Development of an optimized electrochemical process for subsequent coating of 316 stainless steel for stent applicationsJournal of Materials Science: Materials in Medicine, 2006