Modeling and pressure tracking control of a novel electro-hydraulic braking system
Open Access
- 20 March 2018
- journal article
- research article
- Published by SAGE Publications in Advances in Mechanical Engineering
- Vol. 10 (3)
Abstract
A brake-by-wire system is considered the best solution to realize advanced functions in electric vehicles/hybrid electric vehicles and intelligent vehicles. In this article, a novel electro-hydraulic brake system is proposed. The main issues in the development of the proposed electro-hydraulic brake system focus on hydraulic loop design and pressure tracking control. Instead of an accumulator, a large displacement piston pump coupled to a high-power motor is applied to meet the demand of pressure boost. A passive pedal feel simulator is designed to decouple the brake pedal and the wheel cylinders. The high pressure in the wheel cylinders is controlled by de/activating the motor and valves to track the reference pressure. To minimize the pressure instability observed in previous proportional–integral–derivative controller tests, a self-tuning generalized predictive controller is applied. Models of each system’s dynamic process are derived, and the parameters are identified through test data. A sliding mode differentiator is used to filter the sensor signals and improve the pressure boost performance in hard brake maneuvers. A rapid control prototype test environment based on dSPACE is built to verify and adjust the controller. The simulation results using MATLAB/Simulink and bench tests are presented and analyzed. Tracking performances show that compared to a proportional–integral–derivative controller, the proposed controller has a better effect in lowering pressure overshoots and start–stop frequency.Keywords
Funding Information
- National Natural Science Foundation of China (51505354)
This publication has 21 references indexed in Scilit:
- A robust wheel slip ratio control design combining hydraulic and regenerative braking systems for in-wheel-motors-driven electric VehiclesJournal of the Franklin Institute, 2015
- Sensotronic brake control (SBC)2014
- Adaptive position–pressure control of a brake by wire actuator for sport motorcyclesEuropean Journal of Control, 2014
- Estimation of brake pressure and tyre-road friction during ABS activationInternational Journal of Vehicle Design, 2012
- Electro-hydraulic braking system for autonomous vehiclesInternational Journal of Automotive Technology, 2010
- Electromechanical Brake Modeling and Control: From PI to MPCIEEE Transactions on Control Systems Technology, 2008
- A Study on the Effect of Brake Assist Systems (BAS)SAE International Journal of Passenger Cars - Mechanical Systems, 2008
- Brake System Modeling for Simulation and ControlJournal of Dynamic Systems, Measurement, and Control, 1999
- Properties of generalized predictive controlAutomatica, 1989
- An iterative method for the identification of nonlinear systems using a Hammerstein modelIEEE Transactions on Automatic Control, 1966