Neural network–based modeling to predict residual stresses during electric discharge machining of Al/SiC metal matrix composites
- 4 September 2013
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
- Vol. 227 (11) , 1679-1692
Abstract
This article reports the result of an experimental study to analyze the effect of parameters that induce residual stresses during electric discharge machining of two particulate-reinforced metal matrix composites. Several factors were varied to study their impact on the formation of residual stresses, and pulse-off time was identified as the most significant factor. Artificial neural network was implemented to predict the residual stresses. Metal matrix composites with low coefficient of thermal expansion and high reinforced particle exhibit lower residual stresses. Also, better conductive electrode materials used during machining cause lower residual stress. The artificial neural network model accurately predicts the residual stresses and is a reliable tool for predicting residual stresses. The micrographs show that the workpiece with a higher concentration of reinforced particulates results in lesser flow line in the matrix material hence less residual stresses. X-ray spectra also reveal the phase transformation on the machined surface.Keywords
This publication has 30 references indexed in Scilit:
- A study on surface roughness in abrasive waterjet machining process using artificial neural networks and regression analysis methodJournal of Materials Processing Technology, 2008
- Modeling of electrical discharge machining process using back propagation neural network and multi-objective optimization using non-dominating sorting genetic algorithm-IIJournal of Materials Processing Technology, 2007
- Neural network modelling and parameters optimization of increased explosive electrical discharge grinding (IEEDG) process for large area polycrystalline diamondJournal of Materials Processing Technology, 2004
- Investigation of material removal mechanisms in EDM of composite ceramic materialsJournal of Materials Processing Technology, 2004
- A study of tool life in hot machining using artificial neural networks and regression analysis methodJournal of Materials Processing Technology, 2002
- Influence of EDM pulse energy on the surface integrity of martensitic steelsJournal of Materials Processing Technology, 1998
- Study on modeling of wire EDM processJournal of Materials Processing Technology, 1997
- Sensing tool breakage in face milling with a neural networkInternational Journal of Machine Tools and Manufacture, 1994
- Monitoring drill conditions with wavelet based encoding and neural networksInternational Journal of Machine Tools and Manufacture, 1993
- Sensor Integration Using Neural Networks for Intelligent Tool Condition MonitoringJournal of Engineering for Industry, 1990