Effect of post-weld aging treatment on mechanical properties of Tungsten Inert Gas welded low thickness 7075 aluminium alloy joints
Authors:
- M. TemmarMTM. Temmar
- M. HadjiMHM. Hadji
- T. SahraouiTST. Sahraoui
- 1 June 2011
- journal article
- research article
- Published by Elsevier in Materials & Design (1980-2015)
- Vol. 32 (6) , 3532-3536
Abstract
No abstract availableKeywords
This publication has 14 references indexed in Scilit:
- A comparative analysis of tensile and impact-toughness behavior of cold-worked and annealed 7075 aluminum alloyInternational Journal of Impact Engineering, 2010
- Influence of alloy composition and heat treatment on precipitate composition in Al–Zn–Mg–Cu alloysActa Materialia, 2010
- Characterisation of the composition and volume fraction of η′ and η precipitates in an Al–Zn–Mg alloy by a combination of atom probe, small-angle X-ray scattering and transmission electron microscopyActa Materialia, 2005
- Micromechanical aspects of fatigue in a MIG welded aluminium airframe alloyMaterials Science and Engineering: A, 2005
- Microstructural refinement through inoculation of type 7020 Al–Zn–Mg alloy welds and its effect on hot cracking and tensile propertiesJournal of Materials Processing Technology, 2003
- Softening behaviour of Al–Zn–Mg alloys due to weldingMaterials Science and Engineering: A, 1999
- Origins of hardening in aged AlGuMg(Ag) alloysActa Materialia, 1997
- Solidification cracking susceptibility of high strength aluminum alloy weldmentScripta Materialia, 1996
- Pre-precipitate clustering in an AlCuMgAg alloyScripta Metallurgica et Materialia, 1994
- An electron microscope investigation of the microstructure in an aluminium-zinc-magnesium alloyActa Metallurgica, 1970