Optimization of laser welding of dissimilar corrosion resistant alloys
Open Access
- 1 September 2017
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-5
Abstract
The use of multi-materials components has the benefit of coupling each material's benefit where it is needed, thus achieving, for instance, heat, wear and corrosion resistance. Joining of dissimilar metals is a challenging task due to the large differences in properties. In this framework, the use of (Quasi Continuous Wave (QCW) Fiber Lasers) proved to be effective in multi-materials components assembly thanks to the high power density but low energy-input. In this paper the laser welding of dissimilar materials, namely stellite and stainless steel, is investigated and optimized in terms of corrosion resistance, comparing the results to conventional brazing joining. Results demonstrate that the optimized laser welding conditions, with the use of a proper filler material, lead to the obtainment of defect-free joints, with minimum alteration of the base materials.Keywords
This publication has 11 references indexed in Scilit:
- Laser remelting of plasma-sprayed conventional and nanostructured Al2O3–13wt.%TiO2 coatings on titanium alloyJournal of Alloys and Compounds, 2010
- Microstructure and interfacial evaluation of Co-based alloy coating on copper by pulsed Nd:YAG multilayer laser claddingJournal of Alloys and Compounds, 2010
- Microstructure evolution in Nd:YAG laser-welded (Zr53Cu30Ni9Al8)Si0.5 bulk metallic glass alloyJournal of Alloys and Compounds, 2010
- Galvanised steel to aluminium joining by laser and GTAW processesMaterials Characterization, 2008
- Transmission electron microscopy characterization of laser welding cast Ni-based superalloy K418 turbo disk and alloy steel 42CrMo shaftJournal of Alloys and Compounds, 2008
- Research on laser welding of cast Ni-based superalloy K418 turbo disk and alloy steel 42CrMo shaftJournal of Alloys and Compounds, 2008
- Suppression of intermetallic reaction layer formation by controlling heat flow in dissimilar joining of steel and aluminum alloyMaterials Science and Engineering: A, 2007
- Flux-Less Joining Technique of Aluminium with Zinc-Coated Steel Sheets by a Dual-Spot-Laser BeamAdvanced Materials Research, 2005
- Diode laser brazing of aluminium alloy to steels with aluminium filler metalScience and Technology of Welding and Joining, 2005
- Laser stellite coatings on austenitic stainless steelsMaterials Science and Engineering, 1987