Electrochemical micromachining of silicon platformsfor optical fibre alignment
Authors:
- 25 September 1997
- journal article
- Published by Institution of Engineering and Technology (IET) in Electronics Letters
- Vol. 33 (20) , 1695-1696
Abstract
The authors present an original and low-cost technique for placing and aligning, optical fibres on silicon platforms. Porous silicon obtained by electrochemical etching in delineated areas is used as a sacrificial material. It is shown that this method, which is not dependent on the crystallographic orientations, provides well-defined grooves.Keywords
This publication has 5 references indexed in Scilit:
- Porous silicon as a sacrificial materialJournal of Micromechanics and Microengineering, 1996
- Porous silicon formation mechanismsJournal of Applied Physics, 1992
- Micromachining processes and structures in micro-optics and optoelectronicsJournal of Micromechanics and Microengineering, 1991
- Anisotropic Etching of Crystalline Silicon in Alkaline Solutions: I . Orientation Dependence and Behavior of Passivation LayersJournal of the Electrochemical Society, 1990
- Anisotropic etching of siliconIEEE Transactions on Electron Devices, 1978