Simulations of crystal aggregation and growth: Towards correct crystal area
- 19 January 2019
- journal article
- research article
- Published by Wiley in AIChE Journal
- Vol. 65 (5)
Abstract
Simulating crystal growth and aggregation can provide insight into factors that control the final product properties. Classical models involve formation of a volume‐equivalent single crystal upon aggregation. This approach does not preserve particle area, resulting in an inadequate model of supersaturation depletion. Alternatively, crystal area can be computed accurately by a Monte Carlo method where each primary particle of an aggregate is described in its full geometric complexity. However, the drawback of this method is its computational cost. Thus, a third method is introduced as a compromise, describing particles by their volume and area and preserving both upon aggregation. The so‐obtained two‐dimensional model requires growth rate expressions in volume and area. We provide a method for parametrizing these expressions so that total volume and area closely match the values obtained with the method based on full geometric information. The parameters depend on primary particle geometry and the amount of growth. © 2019 American Institute of Chemical Engineers AIChE J, 65: e16525, 2019Keywords
Funding Information
- Deutsche Forschungsgemeinschaft (BR‐2035/9‐2, BR‐2035/9‐3)
This publication has 38 references indexed in Scilit:
- Measurement, modelling, and closed-loop control of crystal shape distribution: Literature review and future perspectivesParticuology, 2016
- High dimensional population balances for the growth of faceted crystals: Combining Monte Carlo integral estimates and the method of characteristicsChemical Engineering Science, 2015
- Population Balance Modeling: Current Status and Future ProspectsAnnual Review of Chemical and Biomolecular Engineering, 2014
- Morphology evolution of crystal populations: Modeling and observation analysisChemical Engineering Science, 2012
- Convex Geometry for the Morphological Modeling and Characterization of Crystal ShapesParticle & Particle Systems Characterization, 2011
- Crystal Shape EngineeringIndustrial & Engineering Chemistry Research, 2008
- Morphological population balance for modeling crystal growth in face directionsAIChE Journal, 2007
- Simulation of crystal size and shape by means of a reduced two-dimensional population balance modelChemical Engineering Science, 2006
- High-Resolution Simulation of Multidimensional Crystal GrowthIndustrial & Engineering Chemistry Research, 2002
- Habit Transient Analysis in Industrial Crystallization Using Two Dimensional Crystal Sizing TechniqueChemical Engineering Research and Design, 1997