Modelling of the photometric balance for two-wavelength spatially multiplexed digital holography
Authors:
- 20 June 2021
- conference paper
- Published by SPIE-Intl Soc Optical Eng
- Vol. 11783, 6
Abstract
Multi-wavelength digital holography is a very powerful approach for surface shape measurements. It has the advantage of being contact-less, non-intrusive, and yields full-field surface shape data without any requirement for scanning. When dealing with off-axis digital holography and spatial multiplexing of two-wavelength digital holograms, the method becomes real-time, in the sense that the surface shape can be measured at each time instant at which the holograms are recorded. Thus, phase shifting and sequential recording are suppressed. However, due to the roughness of the inspected surface, speckle decorrelation occurs and noise is included in the final data. The noise amount in the data must be investigated in order to define the best processing approach for holograms. This paper proposes the analysis of the standard deviation of noise in surface-shape data from two-wavelength spatially-multiplexed digital holograms. The influence of noise on the measurements of the surface shape is described by an analytical approach. Relationships to quantify the minimum measurable surface height is given by taking into account the experimental parameters of the set-up. These parameters are related to the spatial bandwidths, modulation of holograms, saturation ratio, number of electrons in pixels, readout noise, quantization noise, photon noise, and speckle decorrelation due to roughness. The theoretical modeling is discussed and analysis when considering practical situation for industrial surface shape measurements.Keywords
This publication has 16 references indexed in Scilit:
- Refocus criterion based on maximization of the coherence factor in digital three-wavelength holographic interferometryOptics Letters, 2017
- Quality assessment of combined quantization-shot-noise-induced decorrelation noise in high-speed digital holographic metrologyOptics Express, 2015
- Fast and robust automatic calibration for single-shot dual-wavelength digital holography based on speckle displacementsApplied Optics, 2015
- Two-wavelength method for endoscopic shape measurement by spatial phase-shifting speckle-interferometryApplied Optics, 2004
- Miniaturized digital holography sensor for distal three-dimensional endoscopyApplied Optics, 2003
- Shape measurement of microscopic structures using digital hologramsOptics Communications, 1999
- Speckle decorrelation in surface profilometry by wavelength scanning interferometry.Applied Optics, 1998
- Holographic interferometry using two-wavelength holography for the measurement of large deformationsApplied Optics, 1995
- Two-Wavelength Speckle Interferometric Technique For Rough Surface Contour MeasurementOptical Engineering, 1986
- Testing aspherics using two-wavelength holography: use of digital electronic techniquesApplied Optics, 1984