The reopening of a collapsed fluid-filled elastic tube
Authors:
- 23 January 2007
- journal article
- research article
- Published by Cambridge University Press (CUP) in Journal of Fluid Mechanics
- Vol. 572, 287-310
Abstract
We present an experimental study of the reopening mechanics of a collapsed liquid-filled elastic tube. The experiment is a simple mechanical model of pulmonary airway reopening and aims to assess the robustness of existing theoretical models. A metre-long horizontal elastic tube of inner radius Ri=4.88 ± 0.14mm is filled with silicone oil and is carefully collapsed mechanically. The injection of nitrogen at a constant flow rate results in the steady propagation of an air finger, after the decay of initial transients. This behaviour is observed over the realizable range of the capillary numbers Ca, which measures the ratio of viscous and capillary forces. With increasing Ca, the transition region between the collapsed and reopened sections of the tube shortens, and the height of the tube behind the bubble tip increases. We also find that air fingers can propagate in partially reopened tubes, in which the transmural pressure is negative far behind the finger tip.The effect of viscosity on the reopening dynamics was explored by performing experiments using three different grades of silicone oil, with kinematic viscosities of 1000cS, 200cS and 100cS. A direct comparison between the experimental pressure dependence on Ca and numerical simulations of the zero-gravity three-dimensional airway-reopening model of Hazel & Heil (Trans. ASME: J. Biomech. Engng, vol. 128, 2006, p. 473) highlights some significant differences. Within the experimental parameter range, gravity profoundly influences the reopening mechanics in several ways. The reopening tube is supported by a rigid base, which induces an asymmetry about the horizontal mid-plane of the collapsed tube, resulting in distinct phases of reopening as Ca increases. In addition, buoyancy forces act on the air finger, which is observed to propagate near the top of the cross-section of the tube, leaving a thicker fluid-lining below. In the limit of small Ca, the height of the reopened tube increases significantly with viscosity. Experimental evidence suggests that this increase in viscosity leads to significant changes in the film configuration behind the propagating finger, caused by the increased contribution of buoyancy forces. The altered film configuration changes the mechanical load on the tube walls and, hence, the shape of the reopened tube.Keywords
This publication has 21 references indexed in Scilit:
- Epithelial cell deformation during surfactant-mediated airway reopening: a theoretical modelJournal of Applied Physiology, 2005
- Surface-tension-induced buckling of liquid-lined elastic tubes: a model for pulmonary airway closureProceedings of the Royal Society A: Mathematical, Physical and Engineering Sciences, 2005
- Three-dimensional instabilities of liquid-lined elastic tubes: A thin-film fluid-structure interaction modelPhysics of Fluids, 2005
- The steady propagation of a bubble in a flexible-walled channel: Asymptotic and computational modelsPhysics of Fluids, 2002
- Finite Reynolds number effects in the propagation of an air finger into a liquid-filled flexible-walled channelJournal of Fluid Mechanics, 2000
- Interaction between airway lining fluid forces and parenchymal tethering during pulmonary airway reopeningJournal of Applied Physiology, 1995
- Onset of Surface-Tension-Driven Bénard ConvectionPhysical Review Letters, 1995
- An Experimental Model Investigation of the Opening of a Collapsed Untethered Pulmonary AirwayJournal of Biomechanical Engineering, 1995
- Is airway closure caused by a liquid film instability?Respiration Physiology, 1989
- The stability of peripheral airwaysRespiration Physiology, 1970