Process parameter optimization of dmls process to produce AlSi10Mg components
Authors:
- R K ShahRSR K Shah
- P P DeyPDP P Dey
Open Access
- 1 July 2019
- conference paper
- Published by IOP Publishing in Journal of Physics: Conference Series
- Vol. 1240 (1)
Abstract
AlSi10Mg components were produced by Direct Metal Laser Sintering (DMLS) and its physical properties like density and mechanical properties ultimate tensile strength were measured.The experimental analysis showed that energy density and hatch spacing are the vital factors influencing the density of the components, the range of energy density for obtaining the best result was 42.40-63.25 J/mm3.The most important parameter effecting the Ultimate Tensile Strength (UTS) was Laser Power but Hatch Spacing also had an equal importance on the tensile strength but energy density analysis revealed that the highest energy density did not gave the least value of UTS as it was in the case of density.The optimum process parameter for both density and UTS was found to be a Laser Power of 330 W,Scan Speed of 1200 mm/s and Hatch Spacing of 0.15 mm.Keywords
This publication has 11 references indexed in Scilit:
- Microstructural characteristics and mechanical properties of carbon nanotube reinforced AlSi10Mg composites fabricated by selective laser meltingOptik, 2017
- A review on selective laser sintering/melting (SLS/SLM) of aluminium alloy powders: Processing, microstructure, and propertiesProgress in Materials Science, 2015
- Processing AlSi10Mg by selective laser melting: Parameter optimisation and material characterisationMaterials Science and Technology, 2015
- Selective laser melting of AlSi10Mg alloy: Process optimisation and mechanical properties developmentMaterials & Design (1980-2015), 2015
- On the effect of process parameters on properties of AlSi10Mg parts produced by DMLSRapid Prototyping Journal, 2014
- Parametric optimization of selective laser melting for forming Ti6Al4V samples by Taguchi methodOptics & Laser Technology, 2013
- Investigations on Manufacturability and Process Reliability of Selective Laser MeltingPhysics Procedia, 2013
- Comparison of density measurement techniques for additive manufactured metallic partsRapid Prototyping Journal, 2011
- Metering and dispensing of powder; the quest for new solid freeforming techniquesPowder Technology, 2007
- Consolidation phenomena in laser and powder-bed based layered manufacturingCIRP Annals, 2007