A CDMA Dual-Band Zero-IF Receiver With Integrated LNAs and VCOs in an Advanced SiGe BiCMOS Process
Authors:
- Peter BorowitzPBPeter Borowitz
- Richard SchwabRSRichard Schwab
- Robert RuthRRRobert Ruth
- Per KarlsenPKPer Karlsen
- Klaas van ZalingeKZKlaas van Zalinge
- 29 May 2007
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Solid-State Circuits
- Vol. 42 (6) , 1328-1338
Abstract
This paper describes one of the first dual PCS- and CEL-band CDMA receivers that includes LNAs and VCOs on a single die. The PCS-band LNA achieves a noise figure (NF) of 1.5dB and IP3 of +7.5 dBm at 16-dB gain. The PCS demodulating mixer achieves an NF of 5 dB, IP3 of +5 dBm and uncalibrated IP2 of +60 dBm. The PCS VCO is capable of -134 dBc/Hz phase noise at 3.9 GHz and 1.25-MHz offset. A copper BiCMOS process was chosen for both performance and cost benefits, compared with lower geometry CMOSKeywords
This publication has 17 references indexed in Scilit:
- An auto-I/Q calibrated CMOS transceiver for 802.11gIEEE Journal of Solid-State Circuits, 2005
- A CDMA2000 zero-IF receiver with low-leakage integrated front-endIEEE Journal of Solid-State Circuits, 2004
- Improved switched tuning of differential CMOS VCOsIEEE Transactions on Circuits and Systems II: Analog and Digital Signal Processing, 2002
- Tail current noise suppression in RF CMOS VCOsIEEE Journal of Solid-State Circuits, 2002
- A filtering technique to lower LC oscillator phase noiseIEEE Journal of Solid-State Circuits, 2001
- A 2-V 2.5-GHz-104-dBc/Hz at 100 kHz fully integrated VCO with wide-band low-noise automatic amplitude control loopIEEE Journal of Solid-State Circuits, 2001
- A low-noise, low-power VCO with automatic amplitude control for wireless applicationsIEEE Journal of Solid-State Circuits, 1999
- A 1.75-GHz/3-V dual-modulus divide-by-128/129 prescaler in 0.7-μm CMOSIEEE Journal of Solid-State Circuits, 1996
- Low-power monolithic RF peak detector analysisIEEE Journal of Solid-State Circuits, 1995
- A simple three-terminal IC bandgap referenceIEEE Journal of Solid-State Circuits, 1974