High-Frequency High Power Density 3-D Integrated Gallium-Nitride-Based Point of Load Module Design
Authors:
Top Cited Papers
- 1 September 2013
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 28 (9) , 4216-4226
Abstract
The demand for the future power supplies that can achieve higher output currents, smaller sizes, and higher efficiencies cannot be satisfied with the conventional technologies. There are limitations in the switch performance, packaging parasitics, layout parasitics, and thermal management that must be addressed to push for higher frequencies and improved power density. To address these limitations, the utilization of Gallium-Nitride (GaN) transistors, 3-D integrated technique, low-profile magnetic substrates, and ceramic substrates with high thermal conductivity are considered. This paper discusses the characteristics of GaN transistors, including the fundamental differences between the enhancement mode and the depletion mode GaN transistors, gate driving, and the deadtime loss, the effect of parasitics on the performance of high-frequency GaN point-of-load (POLs), the 3-D copackage technique to integrate the active layer with low profile low temperature cofired ceramic magnetic substrate, and the thermal design of a high -density module using advanced substrates. The final demonstrators are three 12-1.2-V conversion POL modules: a single-phase 20 A 900 W/in3 2-MHz converter using enhancement mode GaN transistors, a single-phase10-A 800 W/in3 5-MHz converter, and a two-phase 20-A 1100 W/in3 5-MHz converter using the depletion mode GaN transistors. These converters offer unmatched power density compared to state-of-the-art industry products and research.Keywords
This publication has 9 references indexed in Scilit:
- Hybrid Integration of a Low-Voltage, High-Current Power Supply Buck Converter With an LTCC Substrate InductorIEEE Transactions on Power Electronics, 2010
- High Inductance Density Low-Profile Inductor Structure for Integrated Point-of-Load Converter2009
- A Class of Ceramic-Based Chip Inductors for Hybrid Integration in Power SuppliesIEEE Transactions on Power Electronics, 2008
- System in package with mounted capacitor for reduced parasitic inductance in voltage regulators2008
- System design of a 3D integrated non-isolated Point Of Load converter2008
- Multi Chip Module with Minimum Parasitic Inductance for New Generation Voltage Regulator2005
- Effect and utilization of common source inductance in synchronous rectification2005
- Investigation of candidate VRM topologies for future microprocessorsIEEE Transactions on Power Electronics, 2000
- Design considerations for low-voltage on-board DC/DC modules for next generations of data processing circuitsIEEE Transactions on Power Electronics, 1996