Dynamic Recrystallization of Zircaloy-4 during Working within the Upper α-Range
Authors:
- 15 October 2004
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 467-470, 1151-1156
Abstract
Compression tests were used to simulate simple deformation paths within the upper a-range of Zircaloy-4 (i.e. 500°C-750°C). The mechanical behaviour reveals two different domains : at low temperatures and large strain rates, strain hardening takes place before flow softening, whereas this first stage disappears at lower flow stress levels. Strain rate sensitivity and activation energy were determined for both domains. Dynamic recrystallization was investigated using the Electron BackScattering Diffraction (EBSD) technique. It appears that the mechanism involved here is continuous dynamic recrystallization (CDRX), based on the increasing misorientation of subgrain boundaries and their progressive transformation into large angle boundaries. At low strains (e £ 0.3), CDRX kinetics are similar whatever the deformation conditions, while higher temperatures and lower strain rates promote recrystallization at large strains.Keywords
This publication has 7 references indexed in Scilit:
- Effect of texture and slip mode on the anisotropy of plastic flow and flow softening during hot working of Ti-6Al-4VMetallurgical and Materials Transactions A, 2001
- Effect of initial microstructure on plastic flow and dynamic globularization during hot working of Ti-6Al-4VMetallurgical and Materials Transactions A, 1999
- Flow softening during hot working of Ti-6Al-4V with a lamellar colony microstructureScripta Materialia, 1999
- Flow behavior and globularization kinetics during hot working of Ti–6Al–4V with a colony alpha microstructureMaterials Science and Engineering: A, 1999
- Microstructural study of β treated grade 702 zirconium. Scanning electron microscopy and transmission electron microscopy, complementarity of two observational scalesJournal of Materials Science, 1997
- Modification of alpha morphology in Ti-6Al-4V by thermomechanical processingMetallurgical Transactions A, 1986
- On the process of transition of the cubic-body-centered modification into the hexagonal-close-packed modification of zirconiumPhysica, 1934