Advanced Configuration Parameters of Post Processor Influencing Tensile Testing PLA and Add-Mixtures in Polymer Matrix in the Process of FDM Technology
Open Access
- 5 July 2021
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 11 (13) , 6212
Abstract
The present paper focuses on the configuration possibilities of post -processor influencing mechanical properties of a given test sample produced by the FDM printer from different materials. The research consists of assessing the composite material configurations through a static tensile test conducted on 80 samples produced. The samples were produced based on ISO 527-2 standard, type 1A, with a horizontal position and a layer height of 0.2 mm. The individual samples consisted of four basic groups of materials—the pure Polylactic acid (PLA) plastic (reference sample), and three composite samples with admixtures—PLA matrix with a copper admixture, PLA matrix with an iron admixture, and PLA matrix with a steel admixture. The static tensile test was conducted at a test speed of 5 mm/min. During the research, reference samples (pure PLA) were assessed in five orientations. Samples made of the PLA composite materials with admixtures were manufactured, tested, and evaluated only in the 0° orientation. The paper concludes by comparing the results of measurement with the original material, free from additives, and with the researched influence of the orientation of the prints on the resulting mechanical properties of shear samples and their surface structure. In the conducted experiments, the lowest tensile strength has been demonstrated in test samples the orbital transitions and the upper surface layers of which were parallel to the infill.Keywords
Funding Information
- Agentúra na Podporu Výskumu a Vývoja (APVV -18-0316)
- Kultúrna a Edukacná Grantová Agentúra MŠVVaŠ SR (004TUKE-4/2020)
- Vedecká Grantová Agentúra MŠVVaŠ SR a SAV (1/0431/21)
This publication has 38 references indexed in Scilit:
- Strain-rate-dependent properties of short carbon fiber-reinforced acrylonitrile-butadiene-styrene using material extrusion additive manufacturingRapid Prototyping Journal, 2020
- Thermomechanical characterization of short carbon fiber and short glass fiber-reinforced ABS used in large format additive manufacturingAdditive Manufacturing, 2020
- Strength Comparison of FDM 3D Printed PLA Made by Different ManufacturersTEM Journal, 2020
- Residual strength of additive manufactured ABS parts subjected to fatigue loadingInternational Journal of Fatigue, 2020
- Thermal analysis and phase transformation behaviour during additive manufacturing of Ti–6Al–4V alloyMaterials Science and Technology, 2019
- The influence of printing parameters on selected mechanical properties of FDM/FFF 3D-printed partsIOP Conference Series: Materials Science and Engineering, 2017
- A study on the influence of process parameters on the Mechanical Properties of 3D printed ABS compositeIOP Conference Series: Materials Science and Engineering, 2016
- Dimensional and Surface Texture Characterization in Fused Deposition Modelling (FDM) with ABS plusProcedia Engineering, 2015
- Investigation of the Effect of Built Orientation on Mechanical Properties and Total Cost of FDM PartsProcedia Materials Science, 2014
- Experimental investigation and empirical modelling of FDM process for compressive strength improvementJournal of Advanced Research, 2012