Studying Plasticity in Hard and Soft Nb–Co Intermetallics
- 21 June 2012
- journal article
- research article
- Published by Wiley in Advanced Engineering Materials
- Vol. 14 (11) , 991-997
Abstract
It is shown that micropillar compression can be used to study the plastic flow behavior of both a hard, brittle cubic Laves phase, NbCo2, and a related monoclinic compound, Nb2Co7, which is known to be softer, but is also brittle and has, so far, only been prepared in a fine‐grained form. Flow in the Laves phase occurs at a shear stress of 3.1 GPa on the $\left\langle {0{\bar {1}}{\bar {1}}} \right\rangle $ {111} slip system, consistent with previous observations and estimates from hardness measurement. Micropillar compression and electron microscopy of single crystals of Nb2Co7 indicates that flow takes place parallel to the (001) plane, with $\left\langle {100} \right\rangle $ and $\left\langle {110} \right\rangle $ type Burgers vectors, at a critical resolved shear stress between 0.1 and 0.5 GPa. It is shown that this is much less than predicted by hardness measurements, consistent with the idea that the hardness of plastically anisotropic materials is determined by flow on the hardest operating slip system.
Keywords
This publication has 24 references indexed in Scilit:
- Effect of Laves phase strengthening on the mechanical properties of high Cr ferritic steels for solid oxide fuel cell interconnect applicationMaterials Science and Engineering: A, 2011
- Unusual mechanical behaviour of the intermetallic phase Nb2Co7Materials Science and Engineering: A, 2008
- Experimental reinvestigation of the Co–Nb phase diagramIntermetallics, 2008
- The effect of long-term thermal exposures on the microstructure and properties of CMSX-10 single crystal Ni-base superalloysMaterials Science and Engineering: A, 2004
- Scaling, dimensional analysis, and indentation measurementsMaterials Science and Engineering: R: Reports, 2004
- Physical metallurgy and mechanical properties of transition-metal Laves phase alloysIntermetallics, 2000
- High temperature mechanical properties of C15 Laves phase Cr2Nb intermetallicsMaterials Science and Engineering: A, 1995
- Structure block stacking in intermetallic compounds. I. The rhombohedral-hexagonal M
n+1 X 5n−1 and the monoclinic-hexagonal-trigonal-orthorhombic M
n+1 X 5n+2 structure seriesActa Crystallographica Section B: Structural Science, Crystal Engineering and Materials, 1975
- Plastic flow in glassProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1964
- The theory of indentation and hardness testsProceedings of the Physical Society (1926-1948), 1945