Highly Crystalline Lithium Titanium Oxide Sheets Coated with Nitrogen‐Doped Carbon enable High‐Rate Lithium‐Ion Batteries
- 8 July 2014
- journal article
- research article
- Published by Wiley in ChemSusChem
- Vol. 7 (9) , 2567-2574
Abstract
Sheets of Li4Ti5O12 with high crystallinity are coated with nitrogen‐doped carbon (NC‐LTO) using a controlled process, comprising hydrothermal reaction followed by chemical vapor deposition (CVD). Acetonitrile (CH3CN) vapor is used as carbon and nitrogen source to obtain a thin coating layer of nitrogen‐doped carbon. The layer enables the NC‐LTO material to maintain its sheet structure during the high‐temperature CVD process and to achieve high crystallinity. Doping with nitrogen introduces defects into the carbon coating layer, and this increased degree of disorder allows fast transportation of lithium ions in the layer. An electrode of NC‐LTO synthesized at 700 °C exhibits greatly improved rate and cycling performance due to a markedly decreased total cell resistance and enhanced Li‐ion diffusion coefficient (DLi). Specific capacities of 159.2 and 145.8 mA h g−1 are obtained using the NC‐LTO sheets, at charge/discharge rates of 1 and 10 C, respectively. These values are much higher than values for LTO particles did not undergo the acetonitrile CVD treatment. A capacity retention value as high as 94.7 % is achieved for the NC‐LTO sheets after 400 cycles in a half‐cell at 5 C discharge rate.Keywords
Funding Information
- National Key Basic Research Program of China (2014CB932400)
- National Natural Science Foundation of China (51202121, 51232005, U1330123)
- Shenzhen Technical Plan Project (JC201005310705A, JCYJ20120619152808478, JCYJ20130402145002382)
- Guangdong Province Innovation R&D Team Plan for Energy and Environmental Materials (2009010025)
This publication has 49 references indexed in Scilit:
- Challenges in the development of advanced Li-ion batteries: a reviewEnergy & Environmental Science, 2011
- Nanostructured Anode Material for High‐Power Battery System in Electric VehiclesAdvanced Materials, 2010
- On the Electrochemical Behavior of Aluminum Electrodes in Nonaqueous Electrolyte Solutions of Lithium SaltsJournal of the Electrochemical Society, 2010
- Building better batteriesNature, 2008
- Nano-Sn/hard carbon composite anode material with high-initial coulombic efficiencyJournal of Power Sources, 2008
- Electrochemical impedance spectroscopy study of the SEI formation on graphite and metal electrodesJournal of Power Sources, 2006
- High-Resolution In-Situ Structural Measurements of the Li4/3Ti5/3O4 “Zero-Strain” Insertion MaterialThe Journal of Physical Chemistry B, 2002
- Issues and challenges facing rechargeable lithium batteriesNature, 2001
- Zero‐Strain Insertion Material of Li [ Li1 / 3Ti5 / 3 ] O 4 for Rechargeable Lithium CellsJournal of the Electrochemical Society, 1995
- Spinel Anodes for Lithium‐Ion BatteriesJournal of the Electrochemical Society, 1994