Experimental investigation on enhancing grindability using alkaline-based fluid for grinding Ti-6Al-4V
- 24 May 2018
- journal article
- research article
- Published by Taylor & Francis in Materials and Manufacturing Processes
- Vol. 33 (16) , 1775-1781
Abstract
In the present experimental study, suitability of using alkaline cutting fluid over conventional metalworking fluid for grinding of titanium alloy is critically analyzed when applied through small quantity cooling and lubrication (SQL) technique during up-grinding mode using alumina wheel. Twenty passes have been executed for each grinding condition with infeed, 10 µm per pass. Variation of normal and tangential forces during each pass of grinding has been measured. The grinding (G) ratio has been evaluated and the typical surface roughness parameters of the ground substrate have been measured. The surface quality of the ground substrate and the chip-form have been observed under high-resolution microscope. Substantial improvement in grindability of Ti-6Al-4V has been observed while using alkaline coolant in SQL mode over dry grinding and grinding using conventional coolant in SQL mode. Force requirement and surface roughness have been found to be reduced whereas improvements in G ratio and surface quality have been observed while grinding Ti-6Al-4V using alkaline coolant.Keywords
This publication has 25 references indexed in Scilit:
- Improvement of lubrication and cooling in grindingMaterials and Manufacturing Processes, 2017
- Influence of rotational speed on process characteristics in friction surfacing of Ti-6Al-4VMaterials and Manufacturing Processes, 2016
- Grinding of Ti-6Al-4V Under Small Quantity Cooling Lubrication Environment Using Alumina and MWCNT NanofluidsMaterials and Manufacturing Processes, 2016
- Phase Transition at High Heating Rate and Strain Rate During Maraging Steel C250 GrindingMaterials and Manufacturing Processes, 2015
- Cryogenic Drilling of Ti–6Al–4V Alloy Under Liquid Nitrogen CoolingMaterials and Manufacturing Processes, 2015
- Experimental Investigation on Rotary Ultrasonic Face Grinding of SiCp/Al CompositesMaterials and Manufacturing Processes, 2015
- Grinding Force, Specific Energy and Material Removal Mechanism in Grinding of HVOF-Sprayed WC–Co–Cr CoatingMaterials and Manufacturing Processes, 2014
- Investigation of Cooling Environments in Grinding EN 31 SteelMaterials and Manufacturing Processes, 2013
- Development of a Grinding Fluid Delivery Technique and Its Performance EvaluationMaterials and Manufacturing Processes, 2012
- Performance of Diamond and CBN Single-Layered Grinding Wheels in Grinding TitaniumMaterials and Manufacturing Processes, 2008