Validation of diagnostic monitoring technical state of iron and steel works transformers
Authors:
- 1 February 2016
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 596-600
Abstract
By the example of OJSC Magnitogorsk Iron and Steel Works, the paper considers the issues of introduction of systems designed for diagnostic monitoring technical state of transformers. It highlights the need for life extension and managing priorities at renovation of power equipment. It gives an estimate of the most deteriorated transformers differing in the levels of supplied voltage. Network and unit transformers are distributed according to the operation durability. The study provides dependencies of the specific damage rate and registers their dependencies on provisions of the theory considering failures of the process systems. It determines characteristic failures of the network and unit transformers. There is a list of process disturbances accompanied by internal short circuits. It is proved that most damages appear in the windings and at the high-voltage inputs. The paper takes a look at issues of technical- and-economic efficiency of commercialization of diagnostic monitoring systems. Expenditures for complex inspection and introduction of the stationary system are compared. The study provides evidence to the fact that efficiency of accident prevention and reduction of corresponding losses are significantly higher due to the use of the monitoring systems compared to the routing inspections. It specifies results of introduction of the systems for continuous condition control of network, unit and furnace transformers at OJSC Magnitogorsk Iron and Steel Works. There is a challenge to develop the engineering practice for failure detection and identification.Keywords
This publication has 4 references indexed in Scilit:
- System for Real-Time Monitoring of the Technical State of a Transformer on an Ultrahigh-Power Electric-Arc Steelmaking FurnaceMetallurgist, 2015
- Diagnostic Functions of a System for Continuous Monitoring of the Technical Condition of the Transformers of Arc Steelmaking FurnacesMetallurgist, 2014
- Information and measuring system for electric arc furnace transformer monitoring2014
- Metodology of calculation of the reliability indexes and life time of the electric and mechnical systems2014