Numerical simulation of lignocellulosic biomass gasification in concentric tube entrained flow gasifier through computational fluid dynamics
Open Access
- 2 April 2019
- journal article
- research article
- Published by SAGE Publications in Energy Exploration & Exploitation
- Vol. 37 (3) , 1073-1097
Abstract
Thermochemical conversion of biomass is an encouraging way for the production of syngas. In the present research, four different biomass materials were used for gasification which includes rice husk, cotton stalks, sugarcane bagasse, and sawdust. These biomass sources were selected because they are common Pakistani feedstocks. Gasification of selected biomasses was performed using concentric tube entrained flow gasifier. Three-dimensional computational fluid dynamics model was used to investigate the impacts of kinetic rate and diffusion rate on the gasification performance. The Euler–Lagrange method was used for the development of entrained flow biomass gasifier using commercial computational fluid dynamics code ANSYS FLUENT®14. Discrete phase model was used to predict the movement of particles, whereas the gas phase was treated as the continuous phase with a standard k–ε turbulent model to predict the behavior of gas phase flow. Finite rate/Eddy dissipation model was applied for the calculation of homogenous and heterogeneous reaction rates. Oxygen was used as a gasifying agent. Cotton stalks and sugarcane bagasse produced higher mole fractions of hydrogen (H2) and carbon monoxide (CO) than sawdust and rice husk. Regarding carbon conversion efficiency, cold gas efficiency, and higher heating value cotton stalks and sugarcane bagasse produced better syngas quality as compared to sawdust and rice husk. The oxygen/fuel (O/F) ratio is a key operating parameter in the field of gasification and combustion. The O/F ratio above 0.42 favored combustion reactions and increased mole fraction of water vapor (H2O) and carbon dioxide (CO2) in syngas composition, whereas gasification reactions dominated below 0.42 O/F ratio, resulting increased mole fraction of H2 and CO in syngas composition.Keywords
This publication has 41 references indexed in Scilit:
- Biomass gasification for hydrogen productionInternational Journal of Hydrogen Energy, 2011
- Effect of turbulence and devolatilization models on coal gasification simulation in an entrained-flow gasifierInternational Journal of Heat and Mass Transfer, 2010
- Numerical and experimental investigations on gas–particle flow behaviors of the Opposed Multi-Burner GasifierEnergy Conversion and Management, 2009
- Biomass–oxygen gasification in a high-temperature entrained-flow gasifierBiotechnology Advances, 2009
- Combustion and environmental performance of clean coal end productsInternational Journal of Energy Research, 2007
- Performances of pulverized coal injection in blowpipe and tuyere at various operational conditionsEnergy Conversion and Management, 2007
- Comparison of Shell, Texaco, BGL and KRW gasifiers as part of IGCC plant computer simulationsEnergy Conversion and Management, 2005
- Application of the Rosin–Rammler and Gates–Gaudin–Schuhmann models to the particle size distribution analysis of agglomerated corkMaterials Characterization, 2004
- Performance analysis of a biomass gasifierEnergy Conversion and Management, 2002
- The combustion rates of coal chars: A reviewSymposium (International) on Combustion, 1982