Fluid Dynamics of a Pre-Swirl Rotor-Stator System
- 1 October 2003
- journal article
- Published by Wiley in Journal of Turbomachinery
- Vol. 125 (4) , 641-647
Abstract
In a “direct-transfer” pre-swirl supply system, cooling air flows axially across the wheel-space from stationary pre-swirl nozzles to receiver holes located at a similar radius in the rotating turbine disc. This paper describes a combined computational and experimental study of the fluid dynamics of such a system. Measurements of total and static pressures have been made using a purpose-built rotor-stator rig, with 24 pre-swirl nozzles on the stator and 60 receiver holes in the rotor. The number of pre-swirl nozzles could be reduced, and it was possible to calculate CD, the discharge coefficient of the receiver holes. Information on the flowfield was also obtained from three-dimensional, incompressible steady turbulent flow computations. The measurements showed that there was a significant loss of total pressure between the outlet from the pre-swirl nozzles and the rotating core of fluid in the wheel-space. This loss increased as the pre-swirl flow-rate and inlet swirl ratio increased, and as the number of nozzles decreased. CD increased as the swirl ratio at the receiver hole radius approached unity; also CD decreased as the number of nozzles decreased. Computed pressures and tangential velocities were in mainly good agreement with the measurements. The computations help to explain the reasons for the significant losses in total pressure and for the relatively low values of CD in this pre-swirl system.Keywords
This publication has 7 references indexed in Scilit:
- Discharge Coefficients of a Pre-Swirl System in Secondary Air Systems2001
- Predictions of effect of swirl on flow and heat transfer in a rotating cavityInternational Journal of Heat and Fluid Flow, 2001
- Heat Transfer in a “Cover-Plate” Preswirl Rotating-Disk SystemJournal of Turbomachinery, 1999
- Flow in a “Cover-Plate” Preswirl Rotor–Stator SystemJournal of Turbomachinery, 1999
- CFD Analysis of Coverplate Receiver FlowJournal of Turbomachinery, 1998
- Flow and Heat Transfer in a Preswirl Rotor–Stator SystemJournal of Turbomachinery, 1997
- Application of the energy-dissipation model of turbulence to the calculation of flow near a spinning discLetters in Heat and Mass Transfer, 1974