A Dynamic-Adjusting Threshold-Voltage Scheme for FinFETs low power designs
- 1 May 2013
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 437 (02714302) , 129-132
Abstract
In this paper, a novel device/circuit co-design scheme, namely Dynamic-Adjusting Threshold-Voltage Scheme (DATS) for independent-gate mode FinFET circuits has been proposed. The main idea of this scheme is that a pair of back-gate bias of FinFETs is adjusted dynamically to change threshold voltage according to the system operating frequency and operating mode, which could optimize circuit power, especially leakage power. The experimental and simulation result shows that the leakage power dissipation reduced greatly when circuits operate at the lower frequency, and the energy-delay product of FinFET circuits is reduced by 30% approximately.Keywords
This publication has 6 references indexed in Scilit:
- FinFET Circuit Design2010
- Threshold voltage and bulk inversion effects in nonclassical CMOS devices with undoped ultra-thin bodiesSolid-State Electronics, 2007
- Self-adjusting threshold-voltage scheme (SATS) for low-voltage high-speed operation2002
- 50% active-power saving without speed degradation using standby power reduction (SPR) circuit2002
- FinFET-a self-aligned double-gate MOSFET scalable to 20 nmIEEE Transactions on Electron Devices, 2000
- Dynamic threshold-voltage MOSFET (DTMOS) for ultra-low voltage VLSIIEEE Transactions on Electron Devices, 1997