On the Shear Degradation of Lost Circulation Materials

Author:

Abstract
The introduction of large size materials in the drilling mud circuit has become a common practice over the past few decades for the mitigation of Lost Circulation while drilling in permeable intervals. Solids with an average diameter larger than 100 pm are carried with the drilling mud and, when fractures occur, they deposit at the opening of the fractures, successfully blocking the discharge of fluid out of the wellbore. The effectiveness of such material has been observed, however, to decline over time as the drilling mud circulates through the mud pumps, the drill string, the bit nozzles, the wellbore annulus, and the mud recycling system. The decline over time in the effectiveness of Lost Circulation Materials (LCM) and Loss Prevention Materials (LPM) during drilling is widely linked to the degradation of the LCM/LPM components whose average size drops with circulation time. A large amount of literature in the petroleum industry is dedicated to the investigation of the issue and numerous experimental studies have attempted to quantify the LCM degradation by reproducing the root phenomena in laboratory. The concept of "shear degradation" has thus become a synonym for such studies and it is widely used for the selection of materials to be used in drilling operations. In the present paper, a harder look is taken on the very concept of "shear degradation" and on its effectiveness in capturing the progressive size reduction of LCM/LPM during circulation. Using dimensional analysis, the tendency of a material to degrade can be determined in advance, whereby the density of the particles and suspending fluid, the size of particles, and the fluid viscosity are examined as the governing parameters. Understanding the underlying physics enables the selection of a more shear-resistant engineered-particle drilling fluid, regardless of its application.