Analysis and filter design of differential mode EMI noise for GaN-based interleaved MHz critical mode PFC converter
Authors:
- 1 September 2014
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- Vol. 1 (23293721) , 4784-4789
Abstract
Power factor correction (PFC) converter consumes a large part of volume of power supply. Typical switching frequency of commercial PFC converter is usually not higher than several hundred kHz. Increasing the switching frequency of PFC converter to MHz by using GaN devices can greatly reduce the size and increase power density of power supply. In order to eliminate the high turn-on loss of cascode GaN device, critical conduction mode (CRM) is applied. However, when operating on CRM, PFC converter has large inductor current ripple and variable switching frequency. This makes the differential mode (DM) noise a serious issue for CRM PFC converter. This paper provides a more accurate model to calculate the switching frequency and DM noise of MHz CRM PFC converter. Based on the model and experiment result, interleaving impact of DM noise for MHz CRM PFC converter is analyzed. DM noise filter is designed and it demonstrates that increasing the switching frequency of PFC converter to MHz can greatly increase the corner frequency of DM filter and reduce the filter size significantly.Keywords
This publication has 5 references indexed in Scilit:
- DM EMI Noise Prediction for Constant On-Time, Critical Mode Power Factor Correction ConvertersIEEE Transactions on Power Electronics, 2012
- Guideline for a Simplified Differential-Mode EMI Filter DesignIEEE Transactions on Industrial Electronics, 2009
- Differential Mode Input Filter Design for a Three-Phase Buck-Type PWM Rectifier Based on Modeling of the EMC Test ReceiverIEEE Transactions on Industrial Electronics, 2006
- Evaluation of input current in the critical mode boost PFC converter for distributed power systems2002
- The determination of the boundaries between continuous and discontinuous conduction modes in PWM DC-to-DC converters used as power factor preregulatorsIEEE Transactions on Power Electronics, 1995